REP-TAT-P-1353-01 Remove high pressure pump

WARNING: Working on fuel system.
Risk of fire! Danger of explosion!

When working on the fuel system, make sure that the workbay is sufficiently ventilated, e.g. using extraction unit.
Tightly seal off open lines and connections; collect any leakage fuel directly at the point of exit.
No fire, sparks, open flames or smoking.

NOTE: RISK OF DAMAGE
Damage to the ignition coil.
The silicone hose of the ignition coil must not be contaminated by fuel as this can lead to failure of the ignition coil.

When working on the fuel system, cover the ignition coils with suitable materials and remove where required.
Do not oil or grease the silicone tube of the spark plug socket. The silicone tube is coated with talcum powder to reduce the pulling forces.

Unlock and loosen connector (1).
Unscrew the bolts (arrows) in alternating order .
Feed out high pressure pump (2) and remove.
Motor oil may leak when detaching the high pressure pump (2), have a cleaning cloth ready.

Courtesy of BMW OF NORTH AMERICA, INC.