Engine Repair (F30, 6-CYL RWD) (4 Of 4)

• 11 37 VALVETRONIC
  • 11 37 005 Removing and installing/replacing eccentric shaft (Vehicle with automatic transmission)
    • Notes
    • REP-TAT-P-1137-01 Remove eccentric shaft
    • REP-TAT-P-1137-02 Install eccentric shaft
  • 11 37 005 Removing and installing/replacing eccentric shaft (Vehicle with manual transmission)
    • Notes
    • REP-TAT-P-1137-01 Remove eccentric shaft
    • REP-TAT-P-1137-02 Install eccentric shaft
  • 11 37 010 Removing and installing/replacing intermediate levers
    • Notes
    • REP-TAT-P-1137-05 Checking the position of the intake camshaft
    • REP-TAT-P-1137-05 Check the position of the intake camshaft at cylinder 3 and 4
    • REP-TAT-P-1137-01 Remove torsion springs
    • REP-TAT-P-1137-01 Removing all gates
    • REP-TAT-P-1137-01 Removing all intermediate levers
    • REP-TAT-P-1133-05 Checking installation position of roller cam followers
    • REP-TAT-P-1137-05 Checking the intermediate lever classification
    • REP-TAT-P-1137-02 Installing all intermediate levers
    • REP-TAT-P-1137-02 Installing all gates
    • REP-TAT-P-1137-02 Installing torsion springs
  • 11 37 020 Removing and installing/replacing servomotor for eccentric shaft
    • Notes
    • REP-TAT-P-1137-02 Installing servomotor for the eccentric shaft
    • REP-TAT-P-1354-02 Installing the throttle body
• 11 40 Oil Supply
  • 11 40 000 Checking engine oil pressure
    • Notes
    • REP-TAT-P-1140-05 Checking the oil pressure
• 11 41 Oil Pumps With Strainer And Drive
  • 11 41 000 Removing and installing/replacing oil pump
    • Notes
    • REP-TAT-P-1141-01 Remove the oil vacuum pump
    • REP-TAT-P-1141-25 When replacing the oil vacuum pump: Remount installed parts
    • REP-TAT-P-1141-03 Install the oil vacuum pump
  • 11 41 115 Removing and installing/replacing hydraulic valve for oil-pressure control (for oil pressure control) (Vehicles with automatic transmission)
    • Notes
    • REP-TAT-P-1141-01 Removing the hydraulic valve for the oil pressure control
    • REP-TAT-P-1141-02 Installing the hydraulic valve for the oil pressure control
  • 11 41 115 Removing and installing/replacing hydraulic valve for oil-pressure control (for oil pressure control) (Vehicles with manual transmission)
    • Notes
    • REP-TAT-P-1153-01 Remove connecting bracket on the engine block
    • REP-TAT-P-1141-01 Removing the hydraulic valve for the oil pressure control
    • REP-TAT-P-1141-02 Installing the hydraulic valve for the oil pressure control
• 11 42 Oil Filter And Pipes
  • 11 42 020 Removing and installing/replacing full-flow oil filter completely
    • Notes
    • REP-TAT-P-1142-01 Remove full-flow oil filter
    • REP-TAT-P-1142-25 Replacing: Remount oil-to-water heat exchanger
    • REP-TAT-P-1142-02 Install full-flow oil filter
  • 11 42 200 Removing and installing/sealing or replacing oil feed line for exhaust turbocharger
    • Notes
    • REP-TAT-P-1142-01 Remove oil feed line
    • REP-TAT-P-1142-02 Install oil feed line
  • 11 42 210 Removing and installing/sealing or replacing oil return line for exhaust turbocharger
    • Notes
    • REP-TAT-P-1142-01 Removing the oil return line for the exhaust turbocharger
    • REP-TAT-P-1142-02 Installing the oil return line for the exhaust turbocharger
• 11 44 Oil Cooler W Feed And Discharge Lines
  • 11 44 000 Removing and installing, sealing replacing oil coolant heat exchanger
    • Notes
    • REP-TAT-P-1353-01-F30 Remove the protective plate for the fuel lines
    • REP-TAT-P-1722-01 Remove transmission oil cooler
• 11 51 Coolant Pump With Drive
  • 11 51 000 Removing and installing/replacing the coolant pump
    • Notes
    • REP-TAT-P-1151-01 Removing the coolant pump
    • REP-TAT-P-1151-02 Installing coolant pumps
  • 11 51 027 Remove and install/replace electric coolant pump for charge air/capacitor
    • Notes
    • REP-TAT-P-1151-01 Remove the electric coolant pump for the charge air cooler or the air conditioning condenser
    • REP-TAT-P-1151-02 Installing the electric coolant pump for the charge air cooler/air conditioning condenser
  • 11 51 028 Removing and installing/replacing auxiliary water pump for exhaust turbocharger
    • Notes
    • REP-TAT-P-1151-01 Removing the auxiliary coolant pump
    • REP-TAT-P-1151-02 Installing the auxiliary coolant pump
  • 11 51 030 Removing and installing/replacing component carrier
    • Notes
    • REP-TAT-P-1151-01 Removing coolant pump with support
    • REP-TAT-P-1151-02 Installing coolant pump with support
• 11 53 Thermostat And Engine-Mounted Coolant Lines
  • 11 53 015 Removing and installing/replacing heat management module
    • Notes
    • REP-TAT-P-1153-01 Remove heat management module
    • REP-TAT-P-1153-02 Install heat management module
  • 11 53 082 Removing and installing/replacing the coolant feed line for the exhaust turbocharger
    • Notes
    • REP-TAT-P-1153-01 Remove coolant feed line
    • REP-TAT-P-1153-02 Install coolant feed line
  • 11 53 087 Removing and installing/replacing both coolant return lines for exhaust turbocharger
    • Notes
    • REP-TAT-P-1153-01 Removing the front section of the coolant return line
    • REP-TAT-P-1153-01 Remove the rear section of the coolant return line (front section is removed)
    • REP-TAT-P-1153-02 Install the rear section of the coolant return line (front section removed)
    • REP-TAT-P-1153-02 Install the front section of the coolant return line
  • 11 53 088 Removing and installing/replacing the coolant return line for the exhaust turbocharger (Coolant return line, part 1)
    • Notes
    • REP-TAT-P-1153-01 Removing the front section of the coolant return line
    • REP-TAT-P-1153-02 Install the front section of the coolant return line
  • 11 53 089 Removing and installing/replacing the coolant return line for the exhaust turbocharger (Coolant return line, part 2)
    • Notes
    • REP-TAT-P-1153-01 Removing the rear section of the coolant return line
    • REP-TAT-P-1153-02 Install the rear section of the coolant return line
  • 11 53 942 Removing and installing (replacing) the connecting branch on the engine block
    • Notes
    • REP-TAT-P-1153-01 Remove connecting bracket on the engine block
    • REP-TAT-P-1153-25 Replacing the connecting bracket on the engine block
    • REP-TAT-P-1153-02 Install connecting bracket on the engine block
• 11 61 Intake System
  • 11 61 050 Removing and installing the intake plenum
    • Notes
    • REP-TAT-P-1161-01 Removing the intake plenum
    • REP-TAT-P-1161-02 Installing the intake plenum
  • 11 61 051 Replacing intake plenum
    • Notes
    • REP-TAT-P-1161-01 Removing the intake plenum
    • REP-TAT-P-1161-02 Installing the intake plenum
  • 11 61 730 Leakage test for the intake system
    • Notes
    • REP-TAT-P-1161-05 Preparing the diagnostic system
    • REP-TAT-P-1161-05 Check air intake system for tightness
• 11 65 Charger With Control
  • 11 65 020 Removing and installing/replacing exhaust turbocharger
    • Notes
    • Troubleshooting on the exhaust turbocharger
      • Notes
      • General notes on troubleshooting
    • REP-TAT-P-1165-01 Remove exhaust turbocharger
    • REP-TAT-P-1142-25 For replacement: Remounting the oil feed line
    • REP-TAT-P-1165-05 Prepare for the installation of the exhaust turbocharger
    • REP-TAT-P-1165-02 Installing exhaust turbocharger
  • 11 65 300 Remove and install or replace the electrical actuator drive for the wastegate
    • Notes
    • REP-TAT-P-1165-01 Remove electric wastegate valve actuator
    • REP-TAT-P-1165-02 Install electric wastegate valve actuator
    • REP-TAT-P-1165-14 Adjusting the electric wastegate valve actuator
• 11 66 Vacuum Pump
  • 11 66 000 Removing and installing/replacing vacuum pump
    • Notes
    • REP-TAT-P-1141-01 Remove the oil vacuum pump
    • REP-TAT-P-1141-25 When replacing the oil vacuum pump: Remount installed parts
    • REP-TAT-P-1141-03 Install the oil vacuum pump
• 11 74 Exhaust-Gas RECIRCULATION Valve
  • 11 74... Vacuum system arrangement
• 11 78 Co Adjustment, Oxygen Sensor
  • 11 78 510 Replacing oxygen sensor (after vehicle diagnosis)
    • Notes
    • REP-TAT-P-1178-25 Replacing the Lambda oxygen sensor
  • 11 78 610 Replacing the lambda oxygen monitoring sensor (after vehicle diagnosis)
    • Notes
    • REP-TAT-P-1178-25 Replacing the oxygen monitor sensor