11 66 000 Removing and installing/replacing vacuum pump: Notes

Preliminary work 

• Refer to LOWERING FRONT AXLE SUPPORT
• Refer to REMOVING THE OIL FILLER CAP
• Release the oil drain plug
• Refer to REMOVING STARTER MOTOR
• Refer to REMOVING OIL SUMP

Follow-up work 

• Refer to REFITTING ENGINE OIL PAN
• Tighten the oil drain plug to 25 Nm.
  NOTE: Replace the sealing ring.
• Refer to INSTALLING STARTER MOTOR
• Refer to RAISING FRONT AXLE SUPPORT
• Check engine oil level
• Top up the engine oil, as necessary