Rear Floor Covering, Removing And Installing: Removing
Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC, ELECTRICAL AND MECHANICAL RESTRAINT SYSTEM COMPONENTS, SAFETY PRECAUTIONS AND TESTING PROCEDURES .
-- Remove the front seats with the seat frames.
- Mechanically adjustable seat. Refer to FRONT DRIVER SEAT OVERVIEW .
- Memory seat, power seat and Comfort seat. Refer to FRONT DRIVER SEAT OVERVIEW .
-- Remove second row seats.
- Seat beach (two-thirds bench). Refer to SECOND ROW, 3 PASSENGER OVERVIEW .
- Individual seat. Refer to SECOND ROW, 2 PASSENGER OVERVIEW .
-- Remove the luggage compartment floor or the left and right supports in the luggage compartment. Refer to LUGGAGE COMPARTMENT FLOOR COVERING OVERVIEW .
-- Remove the left and right wheel housing trim from the C-pillar. Refer to WHEEL HOUSING LINER OVERVIEW .
-- Remove left and right sill panel strip. Refer to SILL PANEL STRIP OVERVIEW .
-- Remove any covers or trims for the connector station, foot vent, etc.
-- Detach the center console from the body brackets. Refer to CENTER CONSOLE OVERVIEW and carefully raise it slightly in the rear area until the rear floor covering can be removed.
-- Pull the floor covering back.
-- Fold the floor covering lengthwise and remove it through a door.