Section 181 (Transmission - Installation Preparations, Removal - M56 (Coupe))
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission
- Transmission, preparations before installing
- Transmission, removing (M56)
- Notes
- Removal
- Disconnecting the battery lead
- Preparatory work
- Draining coolant
- Removing engine compartment components
- Removing components from the transmission
- Removing the vacuum pump from the cylinder head for the engine
- Removing the exhaust gas recirculation (EGR) cooler assembly
- Removing the transmission mounting screws
- Installing the lifting beam and lifting hook on the engine lifting lug
- Removing components from the sub-frame
- Removing the cross members from the body
- Removing the front mounting for the exhaust pipe
- Removing the propeller shaft
- Removing the mounting for the center bearing for the propeller shaft
- Removing the screws and nuts for the engine pads, torque rod and steering gear
- Detaching the power steering line
- Removing front suspension components (both sides)
- Disconnecting the ball joint pinion from the control arm (both sides)
- Removing fender liner components (both sides)
- Removing the screws for the sub-frame support plates (both sides)
- Removing the right drive shaft
- Removing the collision protection system over the steering gear
- Lowering the sub-frame
- Removing the drive shaft from the wheel hub
- Removing the drive shaft from the transmission
- Removing the lower charge air pipe
- Removing bevel gear
- Removing the rear engine mounting
- Hanging up the steering gear
- Removing the screws from the torque converter
- Removing the oil pipe from the transmission
- Lowering the engine and the transmission
- Installing the fixture on the mobile jack and transmission
- Removing all the screws for the transmission and engine
- Removing the transmission