Overview - Clutch Housing
WARNING: This page is about a different variant/trim than selected.
- Bearing Bushing
- For the selector rods
- Always replace if removed
- Removing. Refer to CLUTCH HOUSING, SERVICING .
- Installing. Refer to CLUTCH HOUSING, SERVICING .
- Needle sleeve
- For the reverse shaft
- Always replace if removed
- Removing. Refer to CLUTCH HOUSING, SERVICING .
- Installing. Refer to CLUTCH HOUSING, SERVICING .
- Alignment Sleeve
- Quantity: 2
- Clutch Housing
- When replacing: adjust the output shaft and differential. Refer to ADJUSTMENT OVERVIEW
- Cap
- Not on all clutch housings
- Input Shaft Seal
- Replacing. Refer to INPUT SHAFT SEAL, REPLACING .
- Seal
- For the right flange shaft
- Replacing. Refer to RIGHT SEAL, REPLACING .
- Washer
- For the differential
- Installed position: shoulder on inner diameter faces toward seal -item OVERVIEW - CLUTCH HOUSING-.
- Outer Race/Tapered Roller Bearing
- For the differential
- Removing and Installing. Refer to OVERVIEW - DIFFERENTIAL .
- When replacing: adjust the differential. Refer to DIFFERENTIAL, ADJUSTING
- Oil Deflector Ring
- Installed position: shoulder at hole points toward output shaft
- Outer Race/Tapered Roller Bearing
- Output Shaft, 1st to 4th Gears
- Removing and Installing. Refer to OUTPUT SHAFT, 1ST TO 4TH GEARS, DISASSEMBLING AND ASSEMBLING .
- Adjust, if output shaft for 1st to 4th gear is replaced. Refer to OUTPUT SHAFT 1ST THROUGH 4TH GEAR, ADJUSTING .
- Outer Race/Tapered Roller Bearing
- Output Shaft, 5th/6th and Reverse Gears
- Removing and Installing. Refer to OVERVIEW - OUTPUT SHAFT, 5TH/6TH AND REVERSE GEARS .
- When replacing: adjust output shaft for 5th/6th and reverse gear. Refer to OUTPUT SHAFT, 5TH, 6TH AND REVERSE GEARS, ADJUSTING .
- Washer
- Output Shaft, 5th/6th and Reverse Gears
- Always 0.65 mm thick
- Cylindrical Roller Bearing
- For the input shaft
- Removing and Installing. Refer to OVERVIEW - INPUT SHAFT .
- Magnet
- Held in place by housing joint surface