Adjustment Overview

WARNING: This page is about a different variant/trim than selected.

NOTE:

When performing repairs on the transmission, readjustment of the output shaft for 1st to 4th gears, output shaft for 5th/6th gear and reverse gears or differential is only required if components, which have a direct influence on transmission adjustment, have been replaced. Refer to Table to avoid any unnecessary adjusting.

		To be adjusted:
		Output shaft, 1st to 4th gears. Refer to OUTPUT SHAFT 1ST THROUGH 4TH GEAR, ADJUSTING .	Output shaft, 5th/6th and reverse gears. Refer to OUTPUT SHAFT, 5TH, 6TH AND REVERSE GEARS, ADJUSTING .	Differential Refer to DIFFERENTIAL, ADJUSTING .
Replaced part:	Transmission Housing	x	x	x
	Clutch Housing	x	x	x
	Output Shaft 1st through 4th Gear	x
	Output shaft for 5th/6th and reverse gears		x
	Differential			x
	Output shaft tapered roller bearing, 1st to 4th gears	x
	Output shaft tapered roller bearing, 5th/6th and Reverse Gears		x
	Differential tapered roller bearing			x