Section 39 (Final Drive, Differential - Manual Transmission 0A4 (Sedan) (A5 Platform))

• 39 Final Drive, Differential
  • General Information
    • Right Flange Shaft Seal, Differentiating
  • Description And Operation
    • Adjustment Overview
    • Differential, Adjusting
      • Notes
      • Determining Shim Thickness
  • Specifications
    • Fastener Tightening Specifications
  • Removal And Installation
    • Left Flange Shaft And Seal
    • Right Flange Shaft, Seal And Sleeve, Two Piece
    • Right Flange Shaft, Seal And Sleeve, One Piece
  • Disassembly And Assembly
    • Differential
      • Notes
      • Removing the Outer Race/Tapered Roller Bearing from the Clutch Housing
      • Installing the Outer Race/Tapered Roller Bearing into the Clutch Housing
      • Removing the Bearing Inner Race/Taper Roller Bearing
      • Installing the Bearing Inner Race/Taper Roller Bearing
      • Removing the Outer Race/Tapered Roller Bearing from the Transmission Housing
      • Installing the Outer Race/Tapered Roller Bearing into the Transmission Housing
      • Differentiating the Spring Pins
      • Allocation, Differential Housing
      • Roll Pin with Groove (short roll pin): Removing and Installing
      • Removing the Spring Pin without Surrounding Groove (long spring pin): Removing the Differential Bevel Gear Axle
      • Spring Pin without Surrounding Groove (long spring pin), Installing
      • On Some Transmissions, the Thrust Washer Union has a Ridge -A-
      • Installing the Differential Planetary Gears and Differential Bevel Gear Axle
      • Installed Position: Tapered Ring Thrust Washer -1-
  • Special Tools