Adjustment Overview

WARNING: This page is about a different variant/trim than selected.

NOTE:

If repairs have been performed on the transmission, it is only necessary to adjust the input shaft, output shaft or differential if components have been replaced which have a direct effect on the adjustment of the transmission. Refer to the table to avoid any unnecessary adjusting.

		to be adjusted:
		Input shaft, refer to INPUT SHAFT, ADJUSTING .	Output shaft, refer to OUTPUT SHAFT, ADJUSTING .	Differential, refer to DIFFERENTIAL, ADJUSTING .
Replaced part:	Transmission housing	x		x
	Clutch housing	x	x	x
	Input shaft	x
	Output shaft		x
	Differential housing			x
	Output shaft tapered roller bearing	x
	Output shaft tapered roller bearing		x
	Differential tapered roller bearing			x
	4th gear	x