Removal [09/2022 - 11/2022]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Corolla, 2021 Toyota Corolla, 2020 Toyota Corolla, and 2019 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL ENGINE TO ENGINE STAND
Refer to REMOVAL [09/2022 - 11/2022]
REMOVE ENGINE HANGERS
Refer to PROCEDURE - Step 62
REMOVE THROTTLE BODY ASSEMBLY
Refer to PROCEDURE - Step 3
REMOVE THROTTLE BODY GASKET
Refer to PROCEDURE - Step 4
REMOVE PURGE VALVE (PURGE VSV)
Refer to PROCEDURE - Step 4
REMOVE INTAKE MANIFOLD
Refer to PROCEDURE - Step 3
DISCONNECT FUEL TUBE SUB-ASSEMBLY
Refer to PROCEDURE - Step 6
REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY
Refer to PROCEDURE - Step 7
REMOVE NO. 1 DELIVERY PIPE SPACER
Refer to PROCEDURE - Step 8
REMOVE INJECTOR VIBRATION INSULATOR
Refer to PROCEDURE - Step 9
REMOVE FUEL INJECTOR ASSEMBLY
Refer to PROCEDURE - Step 10
REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
Refer to PROCEDURE - Step 8
REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
Refer to PROCEDURE - Step 2
REMOVE DRIVE SHAFT HEAT INSULATOR SUB-ASSEMBLY
Refer to PROCEDURE - Step 3
REMOVE MANIFOLD STAY
Refer to PROCEDURE - Step 4
REMOVE EXHAUST MANIFOLD
Refer to PROCEDURE - Step 5
REMOVE VENTILATION HOSE
Refer to PROCEDURE - Step 2
DISCONNECT NO. 3 WATER BY-PASS HOSE
Refer to PROCEDURE - Step 14
REMOVE WATER BY-PASS HOSE
Refer to PROCEDURE - Step 16
REMOVE WATER INLET HOSE
Refer to PROCEDURE - Step 17
REMOVE IGNITION COIL ASSEMBLY
Refer to PROCEDURE - Step 1
REMOVE VACUUM PUMP ASSEMBLY
Refer to PROCEDURE - Step 3
REMOVE NO. 1 VACUUM PUMP BRACKET
Refer to PROCEDURE - Step 21
REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
Refer to PROCEDURE - Step 23
REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 12
REMOVE CYLINDER HEAD COVER GASKET
Refer to PROCEDURE - Step 13
SET NO. 1 CYLINDER TO TDC/COMPRESSION
Refer to PROCEDURE - Step 17
REMOVE CRANKSHAFT PULLEY
Refer to PROCEDURE - Step 6
REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY
Refer to PROCEDURE - Step 19
REMOVE TIMING CHAIN COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 20
REMOVE TIMING CHAIN COVER OIL SEAL
Refer to PROCEDURE - Step 21
REMOVE CHAIN TENSIONER SLIPPER
Refer to PROCEDURE - Step 25
REMOVE NO. 1 CHAIN VIBRATION DAMPER
Refer to PROCEDURE - Step 26
REMOVE CHAIN SUB-ASSEMBLY
Refer to PROCEDURE - Step 27
REMOVE CRANKSHAFT TIMING SPROCKET
Refer to PROCEDURE - Step 28
REMOVE NO. 2 CHAIN SUB-ASSEMBLY
Refer to PROCEDURE - Step 29
REMOVE NO. 2 OIL PAN SUB-ASSEMBLY
Refer to PROCEDURE - Step 47

REMOVE OIL PUMP ASSEMBLY

Remove the 3 bolts and oil pump assembly from the stiffening crankcase assembly.