LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Land Cruiser Base >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) - Service Information >> Back Door >> Disassembly [08/2015 - 08/2017] >> Procedure

Disassembly [08/2015 - 08/2017]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [08/2015 - ] ).

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2017] ).

  3. REMOVE BACK DOOR GRIP 
    1. Using moulding remover A, detach the 5 claws.
      GTY581142Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a T30 "TORX" socket wrench, remove the 2 "TORX" screws.
      GTY581143Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Detach the claw and remove the back door grip.
  4. REMOVE LOWER BACK DOOR STOPPER CUSHION 
    1. Remove the 4 bolts and 2 lower back door stopper cushions.
      GTY587435Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE CENTER BACK DOOR GARNISH 
    1. Detach the 5 clips and 4 claws, and remove the back door garnish.
      GTY366868Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE CENTER STOP LIGHT ASSEMBLY 

    Refer to PROCEDURE - Step 2

  7. REMOVE BACK DOOR SIDE GARNISH LH 
    1. Detach the 3 clips and 2 claws, and remove the back door side garnish.
      GTY366869Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE BACK DOOR SIDE GARNISH RH 

    HINT: 

    Use the same procedure described for the LH side.

  9. REMOVE BACK DOOR GARNISH 
    1. Using a clip remover, detach the 14 clips and remove the back door garnish in the direction indicated by the arrow in the illustration.
      GTY552464Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE REAR HEADER SPEAKER ASSEMBLY 

    Refer to PROCEDURE - Step 7

  11. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY 

    Refer to PROCEDURE - Step 6

  12. REMOVE REAR WIPER MOTOR GROMMET 

    Refer to PROCEDURE - Step 7

  13. REMOVE REAR WIPER MOTOR ASSEMBLY 

    Refer to PROCEDURE - Step 8

  14. REMOVE BACK DOOR LOCK COVER 

    Refer to PROCEDURE - Step 5

  15. REMOVE BACK DOOR LOCK ASSEMBLY 

    Refer to PROCEDURE - Step 6

  16. REMOVE LICENSE PLATE LIGHT LENS 

    Refer to PROCEDURE - Step 1

  17. REMOVE BACK DOOR OPENER SWITCH ASSEMBLY 

    See step  1

  18. REMOVE REAR TELEVISION CAMERA ASSEMBLY (w/ Parking Assist Monitor System or Rear View Monitor System) 

    Refer to PROCEDURE - Step 5

  19. REMOVE LIFT GATE WEATHERSTRIP 
    1. Detach the 25 clips and remove the lift gate weatherstrip.
      GTY550998Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Do not pull strongly on the weatherstrip as it may tear.

  20. REMOVE CUSHION 
    1. Remove the 2 cushions.
      GTY585339Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  21. REMOVE LOWER BACK DOOR STOPPER 
    1. Remove the bolt and lower back door stopper.
      GTY538982Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  22. REMOVE REAR LIGHT ASSEMBLY LH 

    Refer to PROCEDURE - Step 5

  23. REMOVE REAR LIGHT ASSEMBLY RH 

    HINT: 

    Use the same procedure described for the LH side.

  24. REMOVE BACK DOOR OUTSIDE GARNISH SUBASSEMBLY 

    Refer to PROCEDURE - Step 3

  25. REMOVE REAR SPOILER SUBASSEMBLY (w/ Rear Spoiler) 
    1. Remove the rear spoiler subassembly (Refer to REMOVAL [08/2015 - 08/2017] ).
  26. REMOVE REAR WASHER NOZZLE 

    Refer to PROCEDURE - Step 3

  27. REMOVE BACK DOOR STAY ASSEMBLY LH 

    See step  1 , or see step  1

  28. REMOVE BACK DOOR STAY ASSEMBLY RH 

    HINT: 

    Use the same procedure described for the LH side.

  29. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE 

    Refer to PROCEDURE - Step 11

  30. REMOVE BACK DOOR TRIM COVER LH 
    1. Remove the back door trim cover LH as shown in the illustration.
      GTY382101Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  31. REMOVE BACK DOOR TRIM COVER RH 
    1. Remove the back door trim cover RH as shown in the illustration.
      GTY366873Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  32. REMOVE BACK DOOR TRIM PANEL ASSEMBLY 
    1. Remove the 4 bolts.
      GTY610950Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the 16 clips and remove the back door trim panel.
  33. REMOVE REAR BUMPER COVER 
    1. Remove the bumper cover (Refer to REMOVAL [08/2015 - 08/2016] , or refer to REMOVAL [08/2016 - ] ).
  34. REMOVE SPARE TIRE 
  35. REMOVE LOWER BACK DOOR TORSION BAR ASSEMBLY 
    1. Remove the 4 bolts and lower back door torsion bar.
      GTY227730Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  36. REMOVE BACK DOOR TORSION BAR GUIDE 
    1. Detach the 2 claws and remove the back door torsion bar guide.
      GTY611054Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  37. REMOVE BACK DOOR INSIDE HANDLE ASSEMBLY 
    1. Remove the screw and back door inside handle.
      GTY600014Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the back door handle grommet.
  38. REMOVE LOWER TAIL GATE LOCK ASSEMBLY RH 
    1. Using a T30 "TORX" wrench, remove the 3 screws and lower tail gate lock.
      GTY578759Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the cable from the lower tail gate lock.
      GTY115801Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  39. REMOVE BACK DOOR REMOTE CONTROL ASSEMBLY 
    1. Remove the 2 screws.
      GTY610970Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the left side cable.
      GTY116045Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the back door remote control.
  40. REMOVE LOWER TAIL GATE LOCK ASSEMBLY LH 
    1. Using a T30 "TORX" wrench, remove the 3 screws and lower tail gate lock.
      GTY539525Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  41. REMOVE TAIL GATE STAY SUBASSEMBLY LH 
    1. Using a T40 "TORX" socket, remove the 2 screws and tail gate stay.
      GTY610753Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  42. REMOVE TAIL GATE STAY SUBASSEMBLY RH 

    HINT: 

    Use the same procedure described for the LH side.

scientia non olet · About LEMON Manuals