Section 29 (Stop And Start System - Diagnostic Codes & Circuit Tests - (Except Hybrid))
WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- Stop And Start System
- DTC P0615-62: Starter Relay Signal Compare Failure [11/2016 - ]
- DTC P0615-19: Starter Relay Circuit Current Above Threshold [11/2016 - ]
- DTC P060B-1C: Analog to Digital Converter Circuit Voltage Out of Range; DTC P060B49: Analog to Digital Converter Internal Electronic Failure; DTC P060B71: Analog to Digital Converter Actuator Stuck [11/2016 - ]
- DTC P0606-29: Backup Boost Converter "A" Control CPU Signal Invalid [11/2016 - ]
- DTC P0555-11: Brake Booster Pressure Sensor Circuit Short to Ground; DTC P055515: Brake Booster Pressure Sensor Circuit Short to Battery or Open [11/2016 - ]
- DTC P0335-62: Crankshaft Position Sensor "A" Signal Compare Failure [11/2016 - ]
- DTC P0555-00: Brake Booster Pressure Sensor (running); DTC P05552A: Brake Booster Pressure Sensor Signal Stuck In Range [11/2016 - ]
- Circuit Tests
- Starter Signal Circuit [11/2016 - ]
- Engine Hood Courtesy Switch Circuit [11/2016 - ]
- Stop and Start Priority Control System [11/2016 - ]
- Backup Boost Converter Circuit [11/2016 - ]
- Neutral Position Switch Circuit [11/2016 - ]
- Stop and Start Cancel Switch Circuit [11/2016 - ]
- Stop and Start System does not Operate (Battery Condition) [11/2016 - ]
- Starter Inrush Current Reduction Relay Circuit [11/2016 - ]
- STA Signal Circuit [11/2016 - ]