Stop and Start System does not Operate (Battery Condition) [11/2016 - ]: Description
WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
When the stop and start system does not operate, check whether the operation is prohibited because the battery conditions are not met.
HINT:
DATA LIST ITEMS
| Hood Courtesy Switch | Battery Current | Battery Temperature (Start) | Battery Temperature |
| Idling Stop Rate | Total Idling Stop Rate | Integrated Current | Status of Battery Charge Control |
| Minimum Voltage (Cranking) | Minimum Voltage (After Cranking) | State of BBC | Stop&Start Operating Permission (Power Management) |
| Stop&Start Operating Permission (Start Minimum Voltage 2) | Stop&Start Operating Permission (Start Minimum Voltage 1) | Stop&Start Operating Permission (Integrated Current) | Stop&Start Operating Prohibition (Jump Start) |
| Battery Type | Ambient Temperature | - | - |
NOTE:
If the Data List item Stop&Start Operating Permission (Power Management) is "NG" even after correcting a certain problem using the diagnostic troubleshooting procedures, the problem may be due to the battery charge amount being temporarily low or the battery may be deteriorated. However, there may be multiple overlapping conditions which are causing system operation to be prohibited, so make sure to always confirm all the diagnostic troubleshooting procedures.