DTC P0335-62: Crankshaft Position Sensor "A" Signal Compare Failure [11/2016 - ]: Description

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

The crankshaft position sensor sends an engine speed signal (NE signal) to the ECM. The engine speed signal is then sent directly from the NEO terminal of the ECM to the engine stop and start ECU. Additionally, the ECM sends the engine speed to the engine stop and start ECU via CAN communication. The engine stop and start ECU compares the NE signal and engine speed received via CAN communication to check for errors in the NE signal.

If the NE signal is abnormal, the engine stop and start ECU will blink the stop and start cancel indicator and stores DTC P033562.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	Warning Indicate	Memory	Note
P033562	Crankshaft Position Sensor "A" Signal Compare Failure	All of the following conditions are met for 10 seconds (1 trip detection logic): Normal communication between the ECM and the engine stop and start ECU. Engine speed (NE signal) is below 6000 rpm. Difference between the NE signal that is sent directly from ECM and the engine speed that is sent via CAN is 300 rpm or higher.	Wire harness or connector Crankshaft position sensor ECM Engine stop and start ECU	Blinks	DTC stored	SAE Code: P0335