LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Legacy 3.6R Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Continuously Variable Transaxle (CVT) (H4DO)) >> Drive Pinion Shaft Assembly >> Installation

Drive Pinion Shaft Assembly: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Clean the mating surface of drive pinion retainer and converter case.
  2. Adjust the backlash and tooth contact between drive pinion shaft assembly and the front differential side gear. <Ref. to ADJUSTMENT , Drive Pinion Shaft Assembly.>
  3. Install O-rings in two locations to the converter case.
    NOTE:
    • Use new O-rings.
    • Apply CVTF to the O-rings.
    Fig 1: O-Rings
    G08318083Courtesy of SUBARU OF AMERICA, INC.
  4. Apply liquid gasket seamlessly to the mating surface of drive pinion retainer.

    Liquid gasket: 

    THREE BOND 1215B or equivalent 

    Fig 2: Liquid Gasket Applying Area - Drive Pinion Retainer
    G08318085Courtesy of SUBARU OF AMERICA, INC.
  5. Install the drive pinion retainer to converter case, and tighten the bolt using the ST.

    ST 18270KA020 SOCKET (E20)

    NOTE: Do not confuse the three different-length bolts when installing.

    Tightening torque: 

    43 N.m (4.4 kgf-m, 31.7 ft-lb) 

    Fig 3: Drive Pinion Retainer Bolts
    G10218887Courtesy of SUBARU OF AMERICA, INC.
  6. Install the forward clutch assembly. <Ref. to INSTALLATION , Forward Clutch Assembly.>
  7. Install the reverse brake assembly. <Ref. to INSTALLATION , Reverse Brake Assembly.>
  8. Install the primary pulley, secondary pulley and variator chain. <Ref. to INSTALLATION , Primary Pulley and Secondary Pulley.>
  9. Install the reduction drive gear. <Ref. to INSTALLATION , Reduction Drive Gear.>
  10. Install the transmission case. <Ref. to INSTALLATION , Transmission Case.>
  11. Install the transmission control device. <Ref. to INSTALLATION , Transmission Control Device.>
  12. Install the oil strainer and oil pan. <Ref. to INSTALLATION , Oil Pan and Strainer.>
  13. Install the reduction driven gear assembly. <Ref. to INSTALLATION , Reduction Driven Gear.>
  14. Install the transfer driven gear assembly. <Ref. to INSTALLATION , Transfer Driven Gear.>
  15. Install the transfer clutch assembly. <Ref. to INSTALLATION , Transfer Clutch.>
  16. Install the parking pawl. <Ref. to INSTALLATION , Parking Pawl.>
  17. Install the extension case. <Ref. to INSTALLATION , Extension Case.>
  18. Install the inhibitor switch. <Ref. to INSTALLATION , Inhibitor Switch.>
  19. Install the secondary speed sensor. <Ref. to INSTALLATION , Secondary Speed Sensor.>
  20. Install the primary speed sensor. <Ref. to INSTALLATION , Primary Speed Sensor.>
  21. Install the turbine speed sensor. <Ref. to INSTALLATION , Turbine Speed Sensor.>
  22. Install the transmission harness. <Ref. to INSTALLATION , Transmission Harness.>
  23. Install the control valve body. <Ref. to INSTALLATION , Control Valve Body.>
  24. Install the air breather hose. <Ref. to INSTALLATION , Air Breather Hose.>
  25. Install the transmission assembly. <Ref. to INSTALLATION , Automatic Transmission Assembly.>
scientia non olet · About LEMON Manuals