Oil Pan and Strainer: Installation

WARNING: This page is about a different variant/trim than selected.

Clean the mating surface of oil pan and transmission case.
Install the O-rings.
NOTE:
- Use new O-rings.
- Apply CVTF to the O-rings.
Install the oil strainer.
Tightening torque:

9 N.m (0.9 kgf-m, 6.6 ft-lb)
Clean the magnet.
Attach the magnet at the specified position of the oil pan.
Apply liquid gasket all around the oil pan mating surface seamlessly.
Liquid gasket:

THREE BOND 1217B (Part No. K0877YA020) or equivalent

Fig 1: Liquid Gasket Applying Area - Oil Pan
Courtesy of SUBARU OF AMERICA, INC.
Install the oil pan by equally tightening the bolts.
Tightening torque:

5 N.m (0.5 kgf-m, 3.7 ft-lb)
Install the under cover - front.
Refill CVTF and adjust the level. <Ref. to REPLACEMENT , CVTF.>