Turbine Speed Sensor: Installation
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Be sure to prevent water or oil from contacting the connector terminal of turbine speed sensor. If adhesion occurs, replace with a new part.
- Install the turbine speed sensor.NOTE:
- Use new O-rings.
- Apply CVTF to the O-rings.
Tightening torque:
7 N.m (0.7 kgf-m, 5.2 ft-lb)
- Connect the harness connector.
- Lower the vehicle.
- Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>