Removing Main Wire Harness In Passenger Compartment
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- 1-3 - Connector for steering column switch
- 4 - Connector for main light switch
- 5 - Connector for ignition lock
- 6 - Connector for diagnostic box
- 7 - Connector for footwell light, left
- 8 - Connector for instrument cluster
- 9-10 - Connector for passenger's airbag, stage 1 and stage 2
- 11 - Connector for footwell light, right
- 12 - Plug connection for glove box
- 13 - Connector for stopwatch
- 14 - Connector for sun sensor
- 15 - Connector for center speaker
- 16-17 - Connector for loudspeaker, left and right
- 18 - Connector for switch console
- 19-20 - Connector for climate control
- 21-26 - Connector for PCM
- 27 - Connector for central locking
- 28 - Connector for hazard warning light switch
- 29-30 - Plug connection for illumination of center nozzle
- 31-32 - Plug connection for illumination of left and right nozzle
- 33-34 - Plug connection between main wire harness and rear wire harness, left and right
- 35-36 - Connector for loudspeaker, rear left and right
- 37-38 - Connector for front seat-belt pretensioner, left and right
- 39-40 - Rubber sleeve
- 41 - Connector for Tiptronic control unit
- 42-43 - Connector for airbag sensor, center left and right
- 44-45 - Connector for ParkAssist control unit
- 46-48 - Connector for control unit for rear convenience systems
- 49 - Ground point under driver's seat
- 50-53 - Connector for telephone control unit
- 54 - Ground point under passenger's seat
- 55-56 - Connector for front seat, left and right
- 57 - Connector for driver's seat with memory
- 58 - Connector for door sill button module
- 59-60 - Plug connection between main wire harness and wire harness for door, left and right
- 61 - Fusebox
- 62 - Relay carrier
- 63-64 - Connector for vehicle electrical system control unit
- 65 - Connector for gateway control unit
- 66-67 - Connector for KESSY/PAS control unit
- 68 - Connector for brake light switch
- 69 - Connector for pedal sensor
- 70 - Plug connection between main wire harness and wire harness for center console
- 71 - Plug connection for telephone handset
- 72 - Connector for airbag triggering unit
- 73 - Connector for parking-brake lever contact switch
- 74-75 - Tiptronic position switch
- 76 - Ground point under unit carrier
- 77 - Connector for tilt sensor control unit
- 78 - Power distributor
- 79-80 - Plug connection between main wire harness and wire harness for heater/air-conditioning unit
- 81-82 - Connector for garage door opener control unit
- 83 - Connector for sunroof switch
- 84 - Connector for interior light
- 85 - Connector for sunroof motor
- 86 - Plug connection for rain sensor
- 87-88 - Plug connection for make-up mirror, left and right
- 89-93 - Connector for antenna unit, left and right
- Release plug connection between main wire harness and rear-end wire harness at the left and right -33 and 34- (-arrow A- ) and disconnect it.
- Pull off connector for front seat-belt pretensioner at the left and right -37 and 38- and remove rubber sleeves -39 and 40- . → Removing Front Three-Point Belt - section on "Removing"
- Release and pull off connector on Tiptronic control unit -41-
. → Removing Tiptronic Control Unit
- section on "Removing"
- 3.1. Unclip wire harness for Tiptronic control unit.
- Release and pull off connector for airbag sensor, center left and right -42 and 43- . → Removing Airbag Sensor - section on "Removing"
- Release and pull off connector for ParkAssist control unit -44 and 45- . → Removing Control Module For ParkAssist - section on "Removing"
- Release and pull off connector on control unit for rear convenience systems -46 to 48- . → Removing Control Unit For Rear Convenience Systems - section on "Removing".
- Loosen ground point under the driver's seat -49-
.
- 7.1. Screw off fastening nut and remove ground straps.
- Unclip ground point under driver's seat.
- Release and remove connectors for telephone control unit -50 to 53-
. → Removing Control Unit For Telephone
- section on "Removing"
- 9.1. Unclip wire harness for telephone control unit.
- Loosen ground point under the passenger's seat -54-
.
- 10.1. Screw off fastening nut and remove ground straps.
- Unclip wire harness at door sill.
- Release and disconnect plug connection between main wire harness and wire harness for door, left and right -59 and 60- . → Removing Wiring Harness For Door - section on "Disconnecting"
- Release and pull off connector for gateway control unit -65- . → Removing Gateway Control Unit - section on "Removing"
- Release and pull off connectors for KESSY/PAS control unit -66 and 67- . → Removing KESSY/PAS control unit - section on "Removing"
- Release and pull off connector for brake light switch -68- . → Removing Stop Light Switch - section on "Removing".
- Release and pull off connector for pedal sensor -69- . → Removing Accelerator Pedal - section on "Removing"
- Loosen ground point under the unit carrier -76-
.
- 17.1. Screw off fastening nut and remove ground straps.
- Release and pull off connector for tilt sensor control unit -77- . → Removing tilt sensor control unit - section on "Removing"
- Disconnect plug connections between main wire harness and wire harness for heater/air-conditioning unit -79 and 80-
.
- 19.1. Release lower plug connection on heater/air-conditioning unit -arrows a- and disconnect it.
- 19.2. Release upper plug connection on heater/air-conditioning unit -arrows a- and disconnect it.
- 19.3. Cut tie-wraps (main wire harness to heater/air-conditioning unit wire harness) with side cutters. Remove main wire harness.
- Release and disconnect plug connection for rain sensor -86- . → Removing rain sensor - section on "Removing"
- Disconnect plug connection for make-up mirror, left and right -87 and 88-
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- 21.1. Unclip plug connection from console -arrow B- .
- 21.2. Release plug connection -arrow a- and disconnect it -arrows C- .
- Unclip cable duct at front of roof frame.
- Unclip main wire harness at front of roof frame.
- Remove main wire harness from A-pillar -area A- .
- Pull off connector for antenna amplifier, left and right -89 through 93- . → Removing Antenna Amplifier - section on "Removing"
- Loosen ground points on dashboard bracket.
- 26.1. Unscrew fastening nuts and remove ground straps.
- Unclip length compensation at the steering column.
- 27.1. Remove expansion rivet and length compensation.
- Unclip cable guide on dashboard bracket.
- Loosen holder for relay carrier.
- 29.1. Unscrew the two fastening screws and remove the relay carrier holder from the dashboard bracket.
- Loosen main wire harness at left dashboard bracket.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- 30.1. Screw off fastening nut and remove fastening screw.
- 30.2. Unclip main wire harness on cable guide.
- Loosen main wire harness at right dashboard bracket.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- 31.1. Unclip main wire harness on both cable guides.
- Loosen main wire harness at center dashboard bracket.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- 32.1. Undo the four tie-wraps and remove main wire harness.