LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2008 >> Cayenne Base, Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 10 - Engine - Crankcase, Suspension >> WM 100119 Removing And Installing 3.6-Litre DFI Engine (Cayenne Tip, Cayenne Man) >> Subsequent Work

Subsequent Work

  1. On vehicles with manual transmission, work on peripheral units must be performed as described in → Installing Transmission .
  2. Install intake pipe. → Installing Air Box For Throttle Housing (Intake Pipe Upstream Of Throttle Valve)
  3. Install cover for plenum panel. → Installing Cowl Panel Cover
  4. Fit pneumatic spring for bonnet → 553119 REMOVING AND INSTALLING FRONT GAS SPRING . While doing so, fit engine compartment rubber seal → Installing Front Lid Seal .
  5. Fill and bleed the cooling system. → Filling The Cooling System (Includes Bleeding)
  6. Bleed brake system. → Bleeding The Brake System
  7. Connect battery. → WM 9000IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY (ALL MODELS)
  8. Mount engine compartment covers. → Installing Front Trim (Engine Compartment)
  9. Check ATF level. → Checking Fluid Level For Power-Assisted Steering
  10. Bleed power-assisted steering. → Checking Fluid Level For Power-Assisted Steering
  11. Install the front wheel housing liners. → Installing Front Wheel Housing Liner
  12. Remove engine guard with transverse strut. → Installing engine guard 
  13. Mount front wheels. → Removing And Installing Wheel
  14. Perform suspension alignment. → SUSPENSION ALIGNMENT, COMPLETE
  15. Perform a test drive with the vehicle. Check the fluid level in the reservoir after the coolant circuit has cooled again and, if necessary, fill up to the max marking with coolant.
  16. Read out DME fault memory and compare with the log you printed prior to removal.
  17. Check engine oil level.
scientia non olet · About LEMON Manuals