Installing Front Wheel Housing Liner

Installing front wheel housing liner 

Fig 1: Identifying Installation Position Of Front Wheel Housing Liner

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. Install wheel housing liner.
   1. 1.1. Fit wheel housing liner -1-  in -direction of arrow-  and align it.
   2. 1.2. Check wheel housing liner -1-  close to the side direction indicator and along the wheel arch to make sure that it is seated correctly.
   3. 1.3. Tighten fastening screws -2-  and fastening nuts -3-  . → Tightening torque: 1.5 Nm (1.0 ft lbs.)+/-0.5 Nm (+/- 0.5 ft lbs.) → Tightening torque: 1.5 Nm (1.0 ft lbs.)+/-0.5 Nm (+/-0.5 ft lbs.). 
      Fig 2: Installing Front Wheel Housing Liner

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Secure servo valve line at the left wheel housing liner.
   1. 2.1. Route servo valve wire harness and push it onto the left wheel housing liner using the retaining clips -arrows-  .
      Fig 3: Securing Servo Valve Line At Left Wheel Housing Liner

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.