LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 175 (Rear Final Drive: Ma241 (Eld)) >> Rear Final Drive: Ma241 (Eld) >> Unit Removal And Installation >> Rear Final Drive >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not damage spline, companion flange and front oil seal when removing propeller shaft.
  • Before removing final drive assembly or rear axle assembly, disconnect ABS sensor harness connector from the assembly and move it away from final drive/rear axle assembly area. Failure to do so may result in sensor wires being damaged and sensor becoming inoperative.
  1. Disconnect the propeller shaft from the rear final drive assembly and support the propeller shaft with suitable wire. Refer to Exploded View .
  2. Disconnect the rear final drive air breather hose from the rear final drive assembly.
  3. Remove the wheel and tire using power tool. Refer to Removal and Installation .
  4. Remove rear brake caliper (RH/LH) and support with wire.
  5. Separate parking brake rear cable from toggle lever (RH/LH). Refer to Exploded View .
  6. Disconnect the following components from the rear final drive assembly.
    • Brake block protector and brake tube block. Refer to Exploded View .
    • Rear brake hose lock plate (RH/LH). Refer to Exploded View .
    • Rear brake pipe (RH/LH) from final drive. Refer to Exploded View .
    • ABS sensor wire harness. Refer to Removal and Installation .
    • Parking brake cables. Refer to Exploded View .
    • Differential lock position switch harness connector (A).
      GNSDB122443Courtesy of NISSAN NORTH AMERICA, INC.
    • Differential lock solenoid harness connector (B).

      SYMBOL

      : Front
  7. Remove the rear stabilizer bar. Refer to Exploded View .
  8. Support rear final drive assembly using a suitable jack.
    CAUTION: Secure rear final drive assembly to jack while removing it.
  9. Remove rear shock absorber lower bolts. Refer to Removal and Installation .
  10. Remove leaf spring U-bolt nuts. Refer to Removal and Installation .
  11. Remove rear final drive assembly.
    CAUTION: Secure rear final drive assembly to the jack while removing it.
scientia non olet · About LEMON Manuals