Section 53 (Radio And Cd Player - Lancer Evolution)
WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
- General Information
- Special Tools
- Diagnosis
- Introduction To Audio System Diagnosis
- Standard Flow Of Diagnostic Troubleshooting
- Diagnosis Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC U0019: Bus Off (CAN-B)
- DTC U0141: ETACS CAN Timeout
- DTC U0151: SRS-ECU CAN Timeout
- DTC U0154: OCM (Occupant Classification-ECU) CAN Timeout
- DTC U0155: Meter CAN Timeout
- DTC U0164: A/C CAN Timeout
- DTC U0168: WCM/KOS CAN Timeout
- DTC U0195: Satellite Radio CAN Timeout
- DTC U1415: Coding Not Completed/Data Fail
- DTC B2420: Power Integrated Circuit
- DTC B2421: Radio Tuner
- DTC B2423: 6 CD Player Error
- DTC B2424: CD Player Error
- DTC B2450: Switch Panel Communication
- DTC B2451: Audio Panel Type Error
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Power Is Not Turned ON When The Power Switch Is Turned ON
- Inspection Procedure 2: No Sound Is Heard
- Inspection Procedure 3: No Sound Is Heard From One Of The Speakers
- Inspection Procedure 3: No Sound Is Heard From One Of The Speakers
- Inspection Procedure 4: The Audio Does Not Operate Normally By Operating The Radio And CD Player Of The Center Panel Unit
- Inspection Procedure 5: Audio Illuminations Does Not Work Normally
- Inspection Procedure 6: The Sound Of Audio Adapter's Input Are Not Played
- Inspection Procedure 7: Noise Is Present While Moving (AM)
- Inspection Procedure 8: Noise Is Present While Moving (FM)
- Inspection Procedure 9: Sound Mixed With Noise, Only At Night (AM)
- Inspection Procedure 10: Broadcasts Can Be Heard But Both AM And FM Have A Lot Of Noise
- Inspection Procedure 11: There Is More Noise On Either AM Or FM
- Inspection Procedure 12: Noise Is Present While Moving (FM)
- Inspection Procedure 13: Noise Appears During Vibration Or Shocks
- Inspection Procedure 14: Noise Is Detected With Engine Running
- Inspection Procedure 15: Constant Noise
- Inspection Procedure 16: Noise Comes Out, But Neither AM Nor FM Sounds
- Inspection Procedure 17: Poor Reception
- Inspection Procedure 18: Distortion On AM Or On Both AM And FM
- Inspection Procedure 19: Distortion On FM Only
- Inspection Procedure 20: Using The Auto Select Function, Too Few Automatic Stations Are Selected
- Inspection Procedure 21: Preset Station Are Erased
- Inspection Procedure 22: CD Can Not Be Inserted
- Inspection Procedure 23: No Sound (CD Only)
- Inspection Procedure 24: CD Sound Skips
- Inspection Procedure 25: Sound Quality Is Poor
- Inspection Procedure 26: CD Can Not Be Ejected
- On-Vehicle Service
- Service Data
- Removal And Installation
- Inspection