Radio And Cd Player Error Codes
WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
If the radio and CD player detects any malfunction in itself or the inserted CD, the error codes below will be shown on the display.
RADIO AND CD PLAYER ERROR CODES REFERENCE CHART
| Error code | Cause | Cause of trouble and its solution |
| ERROR | Power supply error | This error code will be shown if there is any problem in the power supply system of the radio and CD player. Check the connectors and wiring harness of the power supply system, and check that the battery voltage is normal. Check that the same error does not appear. |
| ERROR 01 | Focus error | These error codes will be shown if there is any problem with the CD or there is excessive vibration on the vehicle. If the error codes are not displayed when the vehicle is stopped and another CD is inserted, there is a problem with the CD. Check if there is any of the following problems with the CD.
Repair the CD and insert it again. Then, check that no error appears. |
| ERROR 02 | Abnormal disk | |
| ERROR 03 | Mechanical error | This error codes will be shown if there is any internal mechanical or electrical problem in the radio and CD player. Replace the radio and CD player check that no error codes are shown. |
| ERROR HOT | Protection against high temperature | If the internal temperature is extremely high, this error code will be shown. Turn off the radio and CD player and wait until they cool down. Wait for a while, and then turn on the unit again. Check that the same error does not appear. |
| ERROR DC | Detection abnormal output to the speaker | This error code will be shown if the radio and CD player or the audio amplifier has an internal error or is contaminated with the foreign material, and there is a problem with output to the speaker. If it is contaminated with the foreign material, turn OFF the power. Dry the foreign material if it is liquid, and remove it if it is solid. Then, check if the error code is displayed. If the error code is displayed, replace the radio and CD player or the audio amplifier. |
| i NO SONG | No playable music file is found. | No playable music file is stored in the iPod. Store music files to the iPod. |
| i VER ERROR | iPod cannot be recognized | iPod itself or software is not supported. Use the supported iPod. |
| i CONNECT i RETRY | iPod cannot be authenticated. | iPod is not authenticated. Reconnect. If the error code is not erased after that, the USB box communication may have a problem. Carry out the troubleshooting of "The USB adapter data cannot be replayed". Refer to SYMPTOM PROCEDURES . |
| U NO SONG | No playable music file is found. | No playable music file is stored in the USB memory. Store music files to the USB memory. |
| U FILE ERROR | Playback of unplayable file (copyright protected file, etc.) is attempted. | Displayed when the playback of unplayable file such as a copyright protected file is attempted. The error code is displayed approximately for 3 seconds, and then a next playable file is played automatically. |
| UNSUPPORTED DEVICE | Unsupported device | The USB memory is not supported by the USB box. Use the supported USB memory. |
| UNSUPPORTED FORMAT | Unsupported format | The USB memory is not supported by the USB box. Use the supported USB memory. |
| USB BUS PWR | Overcurrent abnormality | There is a communication error with the USB box. Carry out the troubleshooting of "The USB adapter data cannot be replayed". (Refer to SYMPTOM PROCEDURES . |
| U CONNECT U RETRY | USB memory cannot be authenticated. | The USB memory is not authenticated. Reconnect. If the error code is not erased after that, the USB box communication may have a problem. Carry out the troubleshooting of "The USB adapter data cannot be replayed". Refer to SYMPTOM PROCEDURES . |
| U LSI ERROR | USB box internal error | This error code will be shown when there is a problem in the USB box. Replace the USB box. |