Diagnosis Code Chart
WARNING: This page is about a different variant/trim than selected.
CAUTION:
During diagnosis, a diagnosis code associated with other system may be set when the ignition switch is turned on with connector(s) disconnected. On completion, confirm all systems for diagnosis code(s). If diagnosis code(s) are set, erase them all.
DIAGNOSIS CODE CHART
| DTC No. | Diagnostic item |
|---|---|
| P0703 | Malfunction of stoplight switch |
| P0705 | Malfunction of transmission range switch |
| P0712 | Malfunction of the transmission fluid temperature sensor |
| P0713 | |
| P0715 | Malfunction of primary pulley speed sensor |
| P0720 | Malfunction of secondary pulley speed sensor |
| P0725 | Malfunction of engine speed |
| P0740 | Malfunction of lockup solenoid valve |
| P0741 | Abnormality in lockup function |
| P0745 | Malfunction of line pressure solenoid valve |
| P0746 | Abnormality in hydraulic control system function |
| P0776 | Abnormality in secondary pressure solenoid valve function |
| P0778 | Malfunction of secondary pressure solenoid valve |
| P0815 | Malfunction of paddle shift up switch |
| P0816 | Malfunction of paddle shift down switch |
| P0826 | Malfunction of shift switch assembly |
| P0840 | Malfunction of secondary pressure sensor |
| P0841 | Abnormality in line pressure sensor function |
| P0845 | Malfunction of primary pressure sensor |
| P0868 | Secondary pressure drop |
| P1637 | Malfunction of memory backup |
| P1706 | Malfunction of throttle signal |
| P1710 | Malfunction of vehicle speed signal |
| P1723 | Abnormality in speed sensor system function |
| P1740 | Malfunction of lockup/select switching solenoid valve |
| P1745 | Monitoring of percentage change in pulley ratio |
| P1777 | Malfunction of stepper motor |
| P1778 | Abnormality in stepper motor function |
| P1902 | Malfunction of engine system |
| U0001 | Malfunction of CAN communication circuit |
| U0100 | CAN time-out error (Engine) |
| U0121 | CAN time-out error (ABS) |
| U0141 | CAN time-out error (ETACS) |