Diagnosis Code Chart
WARNING: This page is about a different variant/trim than selected.
CAUTION:
On troubleshooting, if the ignition switch is turned ON while disconnecting connector(s), diagnosis code(s) associated with other system may be set. On completion, confirm all systems for diagnosis code(s). If diagnosis code(s) are set, erase them all.
DIAGNOSIS CODE CHART
| DTC No. | Diagnostic item |
|---|---|
| C1078 | Tire with incorrect diameter equipped |
| C1456 | Wiring harness or coupling coil overcurrent failure |
| C145A | Wiring harness or coupling coil short circuit failure |
| C145D | Wiring harness or coupling open circuit failure |
| C145F | Coupling overload |
| C1460 | Drive mode selector circuit failure |
| C2100 | Abnormal battery voltage (too low) |
| C2101 | Abnormal battery voltage (too high) |
| C211C | Abnormal IG1 power supply low voltage |
| C211D | Abnormal IG1 power supply high voltage |
| C211E | Abnormal power supply voltage (too low) |
| C211F | Abnormal power supply voltage (too high) |
| C2208 | AWD-ECU internal error |
| U0001 | Bus-off error |
| U0100 | Engine CAN time-out |
| U0121 | ABS CAN time-out |
| U0141 | ETACS CAN time-out |
| U0401 | Engine CAN data error |
| U0415 | ABS CAN data error |
| U113C | Wheel speed sensor data error |