REP-TAT-P-2435-25 Replacing the transmission input-RPM sensor (8-speed, AISIN GA8F22AW) (Cooper Clubman S and JCW): Notes

NOTE: When the engine is stopped after the completion of trip, it may be necessary to run the electric fan. In rare cases, operation of the electric fan can last up to 11 min. This protects the components. In this case, replacing the electric fan will not remedy the problem!

Preliminary work:

Refer to REMOVING INTAKE PORT
Refer to REMOVING INTAKE SILENCER HOUSING
Refer to REMOVING CROSS CONNECTION
Refer to REMOVING THE FRONT UNDERBODY PROTECTION
Refer to DRAINING THE OIL FROM THE AUTOMATIC TRANSMISSION
Refer to REMOVING FAN COWL WITH ELECTRIC FAN
Detach the transmission oil cooler from the transmission. Refer to REMOVING AND INSTALLING/REPLACING TRANSMISSION OIL COOLER (GA8G45 / F22AW) (EXCEPT COOPER CLUBMAN JCW) or REMOVING AND INSTALLING/REPLACING TRANSMISSION OIL COOLER (GA8G45 / F22AW) (COOPER CLUBMAN JCW) .
Refer to REMOVING THE COVER (OIL PAN) FOR THE SWITCHING DEVICE (GA8G45 / F22AW)
Refer to DETACHING THE SWITCHING DEVICE (GA8G45 / F22AW)
Replacing the transmission input-RPM sensor (GA8G45 / F22AW)

Release the screw (2).
Remove the transmission input-RPM sensor (1).
Parts: Gearbox input-speed sensor
Install new transmission input-RPM sensor (1).
Tighten down screw (2).

TIGHTENING TORQUE SPECIFICATION

Gearbox input-speed sensor
M6x14
	Torque 6Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work:

Refer to INSTALLING THE SWITCHING DEVICE (GA8G45 / F22AW)
Refer to INSTALLING THE COVER (OIL PAN) FOR THE SWITCHING DEVICE (GA8G45 / F22AW)
Fasten the transmission oil cooler on the transmission. Refer to REMOVING AND INSTALLING/REPLACING TRANSMISSION OIL COOLER (GA8G45 / F22AW) (EXCEPT COOPER CLUBMAN JCW) or REMOVING AND INSTALLING/REPLACING TRANSMISSION OIL COOLER (GA8G45 / F22AW) (COOPER CLUBMAN JCW) .
Refer to INSTALLING FAN COWL WITH ELECTRIC FAN
Refer to TOPPING UP OIL LEVEL IN AUTOMATIC TRANSMISSION (GA8G45 / F22AW)
Refer to INSTALLING THE FRONT UNDERBODY PROTECTION
Refer to INSTALLING CROSS CONNECTION
Refer to INSTALLING INTAKE SILENCER HOUSING
Refer to INSTALLING INTAKE PORT