Removing and installing/replacing fan cowl with electric fan (Cooper)

Only perform this repair work after engine has cooled down.

When the engine is stopped after the completion of trip, it may be necessary to run the electric fan. In rare cases, operation of the electric fan can last up to 11 min. This protects the components. In this case, replacing the electric fan will not remedy the problem!

Preliminary work needed: 

• Remove CROSS CONNECTION .

Removal: 

Remove seal (1) from radiator.

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and detach connector (1) from fan cowl.

Unclip clips (2) from fan cowl and place cable to one side.

Unclip coolant hose and tank vent line from fan cowl (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew the screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock right lock (1) on fan cowl.

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock left lock (1) on fan cowl.

Courtesy of BMW OF NORTH AMERICA, INC.

Feed out fan cowl (1) in arrow direction and remove.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Feed in fan cowl (1) in arrow direction and install.

Courtesy of BMW OF NORTH AMERICA, INC.

Lock left and right locks.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Tightening torque 17 10 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector (1) to fan cowl.

Connector (1) must engage audibly.

Connect clips (2) to fan cowl.

Connect coolant hose and venting line (3) to fan cowl.

Courtesy of BMW OF NORTH AMERICA, INC.

Install seal (1) on radiator.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install CROSS CONNECTION .