REP-TAT-P-2430-02 Install the switching device (Cooper Clubman base)

• Additionally, exchange the wiring harness (1) for vehicles up to 03/2019.

Courtesy of BMW OF NORTH AMERICA, INC.

• Replace the seals (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Position the switching device (1).
• Replace screws (2).

Parts  : Screws

• Tighten the screws (2).

Courtesy of BMW OF NORTH AMERICA, INC.

• Plug the temperature sensor (1) into the switching device.
• Position the hold-down device and tighten the bolt (2).

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect all connectors (1).
• Fasten the connector (2) to the holder.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work: 

• Refer to INSTALLING THE COVER (OIL PAN) FOR THE SWITCHING DEVICE (GA8G45 / F22AW) 
• Refer to INSTALLING FAN COWL WITH ELECTRIC FAN
• Refer to TOPPING UP OIL LEVEL IN AUTOMATIC TRANSMISSION (GA8G45 / F22AW)
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION
• Refer to INSTALLING CROSS CONNECTION
• Refer to INSTALLING INTAKE SILENCER HOUSING
• Refer to INSTALLING INTAKE PORT