Section 3818 (Integrated Suspension Systems - Repair -- F13)
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
- General
- 00 Danger of poisoning if oil is ingested/absorbed through the skin
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety information for working on vehicles with automatic engine start-stop function (MSA)
- 00 Safety instructions for handling oil
- 3710 001 Initial operation with test run of Dynamic Drive
- 37 10 001 Start-up with test run of Dynamic Drive (EPS steering gear)
- 37 12 012 Carry out ride height adjustment
- Front Control And Suspension Elements
- 37 11 030 Removing and installing front left or right spring strut (M6)
- 37 11 030 Removing and installing front left or right spring strut
- 37 11 030 Removing and installing front left or right spring strut (all-wheel drive vehicle)
- 37 11 010 Removing and installing/replacing front active anti-roll bar
- 31 33 100 Replacing front left or right coil spring
- 31 33 100 Replacing front left or right coil spring (M6)
- 37 11 032 Replacing front left or right spring strut (M6)
- 37 11 032 Replacing front left or right spring strut shock absorber
- 37 11 020 Replacing pressure relief valves for active anti-roll bar at front
- Rear Control And Suspension Elements
- 37 12 012 Carry out ride height adjustment
- 37 12 1090 Removing and installing rear left or right spring strut
- 37 12 090 Removing and installing rear left or right spring strut
- 37 12 220 Removing and installing/replacing rear active anti-roll bar
- 37 12 092 Replacing rear left or right spring strut
- 37 12 092 Replacing rear left or right spring strut (EDC)
- Connecting Lines
- 32 41 431 Removing and installing/renewing Dynamic Drive expandable hose part 2 (in front wheel arch) (ESP)
- 32 41 431 Removing and installing/renewing Dynamic Drive expandable hose part 2 (in front wheel arch) (AWD)
- 32 41 431 Removing and installing/renewing Dynamic Drive expansion hose part 2 (in front wheel arch)
- 32 41 431 Removing and installing/replacing ARS expansion hose part 2
- 32 41 435 Removing and installing/replacing ARS return line in wheel arch (N55/N57/N63)
- 32 41 437 Removing and installing/replacing Dynamic Drive return from separation point to cooling loop
- 32 41 435 Removing and installing/replacing Dynamic Drive return in front right wheel arch
- 32 41 436 Removing and installing/replacing return line for hydraulic steering with ARS (N55)
- 32 41 436 Removing and installing/replacing return line for hydraulic steering with ARS (N63)
- 32 41 430 Replacing ARS expandable hose part 1 (from vane pump to expandable hose) (N55)
- 32 41 430 Replacing ARS expandable hose part 1 (from vane pump to expandable hose) N63
- 32 41 430 Replacing ARS expandable hose part 1 (from vane pump to expandable hose) N63T
- 32 41 430 Replacing ARS expandable hose section 1 (from hydraulic pump to expandable hose) (N55)
- 32 41 430 Replacing ARS expandable hose section 1 (from hydraulic pump to expandable hose) N63
- 32 41 420 Replacing expansion hose part 1 (with ARS) (from vane pump) N63
- 32 41 421 Replacing expansion hose part 2 (with ARS) (to the hydraulic steering gear)
- 37 13... Replacing return line (short)
- 37 13 120 Removing and installing/renewing pressure line for VA1 swivel motor
- 37 13 121 Removing and installing/replacing pressure line for valve block VA1
- 37 13 125 Removing and refitting/replacing pressure line on swivel motor VA2
- 37 13 125 Removing and refitting/replacing pressure line on swivel motor VA2 (640i xdr, 650ix)
- 37 13 126 Removing and installing/replacing pressure line for valve block VA2
- 37 13 127 Removing and installing/renewing pressure lines for valve block (short)
- 37 13 130 Removing and installing/replacing underfloor pressure lines for oscillating motor (HA1/HA2)
- 37 13 132 Removing and installing/replacing pressure lines for swivel motor (HA1/HA2)
- Electrical Components
- 37 10 001 Initial operation with test run of Dynamic Drive
- 37 14 055 Removing and installing/replacing Vertical Dynamics Management control unit (VDM with Dynamic Drive)
- 37 14 566 Removing and installing/replacing control unit for Vertical Dynamics Control (EDC)
- 37 14 515 Replacing front left or right ride-height sensor
- 37 14 515 Replacing rear left or right ride height sensor
- 37 10 001 Start-up with test run of Dynamic Drive (EPS steering gear)
- Electronic Damping Force Adjustment
- Pump Assembly With Container