37 14 055 Removing and installing/replacing Vertical Dynamics Management control unit (VDM with Dynamic Drive)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove ignition key
Disconnect BATTERY NEGATIVE LEAD
Remove SIDE TRIM PANEL FROM FOOTWELL ON RIGHT A-PILLAR

Fold carpet in footwell at bottom right to one side.

Release screws (1).

Tightening torque 37 14 6AZ .

Fig 1: Identifying Vertical Dynamics Management Control Unit Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) in direction of arrow and disconnect.

Remove control unit.

Fig 2: Removing Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Replacement only: Carry out PROGRAMMING/ENCODING