37 14 515 Replacing front left or right ride-height sensor

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Unfasten plug connection (1) and disconnect.

Release nut (2) and disconnect jointed rod.

Tightening torque 37 14 4AZ .

Release screw (3) and remove ride-height sensor (4).

Tightening torque 37 14 2AZ .

Fig 1: Identifying Ride-Height Sensor And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1). Remove bracket (2) from ride-height sensor.

Tightening torque 37 14 3AZ .

Fig 2: Identifying Ride-Height Sensor Bracket And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Carry out RIDE-HEIGHT CALIBRATION
Check HEADLIGHT ADJUSTMENT , correct if necessary