41 12 557 Stripping operations - Replacing luggage compartment floor, middle (tail panel removed)
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list basically represents the removal sequence.
The following list basically represents the removal sequence.
- Remove exhaust system (18 00 020 REMOVING AND INSTALLING COMPLETE EXHAUST SYSTEM (N55) ).
- Remove heat shields.
- Remove left and right trailing links (51 71 482 REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT TENSION STRUT (ON REAR AXLE) ).
- Remove cross reinforcement (51 71 480 REMOVING AND INSTALLING/REPLACING CROSS REINFORCEMENT (ON REAR AXLE) or REMOVING AND INSTALLING/REPLACING CROSS REINFORCEMENT (ON REAR AXLE) ).
- If fitted: Remove active anti-roll bar at rear (37 12 220 REMOVING AND INSTALLING/REPLACING REAR ACTIVE ANTI-ROLL BAR ).
- Remove carbon canister (16 12 010 REMOVING AND INSTALLING OR REPLACING CARBON CANISTER , REMOVING AND INSTALLING/REPLACING CARBON CANISTER (US VERSION NVLD) or REMOVING AND INSTALLING/REPLACING CARBON CANISTER (US VERSION WITH DMTL) ).
Undo nut (1) and remove negative battery cable.
Tightening torque 61 21 6AZ .
Undo nut (2) and cable channel.
Undo positive battery cables (3) from luggage compartment floor and put to one side with cable channel.
Remove battery crash support (4).