Retrofit Command Online - AN82.85-P-0009LWH

Model 213.0 (except 213.064/088/089) as of 12/1/17, 213.2 (except 213.264/288/289) as of 12/1/17

with code 246 (Analogue clock)

with code 270 (Aerial for GPS)

with code 3U1 (Headunit europe/CIS-states/Monoglei)

with code 421 (9-speed automatic transmission)

with code 506 (Audio 20 NTG 5.5 radio)

except code 425 (6-speed manual transmission)

except code 448 (Touchpad)

except code 520 (Audio 20 USB)

except code 522 (Audio 20 radio)

Model 213.0 (except 213.064/088/089) up to 11/30/17, 213.2 (except 213.264/288/289) up to 11/30/17

with code 218 (Rear view camera)

with code 235 (Active Parking Assist)

with code 246 (Analogue clock)

with code 270 (Aerial for GPS)

with code 3U1 (Headunit europe/CIS-states/Monoglei)

with code 421 (9-speed automatic transmission)

with code 506 (Audio 20 NTG 5.5 radio)

except code 425 (6-speed manual transmission)

except code 448 (Touchpad)

except code 520 (Audio 20 USB)

except code 522 (Audio 20 radio)

Model 213.0 (except 213.064/088/089) up to 11/30/17, 213.2 (except 213.264/288/289) up to 11/30/17

with code 246 (Analogue clock)

with code 270 (Aerial for GPS)

with code 3U1 (Headunit europe/CIS-states/Monoglei)

with code 421 (9-speed automatic transmission)

with code 506 (Audio 20 NTG 5.5 radio)

except code 218 (Rear view camera)

except code 425 (6-speed manual transmission)

except code 448 (Touchpad)

except code 520 (Audio 20 USB)

except code 522 (Audio 20 radio)

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove
1	Remove display module
			AR54.30-P-6023LWE
2	Remove center console
		Model 213.0/2 with transmission 725	AR68.20-P-2000LWE
3	Remove glove compartment
			AR68.10-P-1402LWE
4	Remove head unit (A26/17) for Audio 20 NTG 5.5 radio
		The head unit (A26/17) is no longer required.	AR82.85-P-1101LWE
5	Remove HERMES control unit
			AR82.95-P-0019LWE
6	Remove passenger seat
			AR91.10-P-1000LW
7	Remove driver's seat
		Model 213 1#	AR91.10-P-1000LW
8	Remove passenger-side floor covering
			AR68.20-P-2065LWE
9	Release rear floor covering (5) on left side and fold to one side until the cable ducts (6) are accessible
			AR68.20-P-4800LWE
10	Open covers on cable ducts (6)
11	Remove ventilation duct (4)
12	Remove footrest (3)
13	Unfasten front passenger side A-pillar fuse box (F1/3)
		Do not disconnect electrical leads.	AR54.15-P-0004LWE
14	Remove Audio/COMMAND control panel (A40/9)
		Model 213.0/2	AR54.21-P-0501LWE
	Install
15	Retrofit touchpad into new Audio/COMMAND control panel (A40/9)		AN82.60-P-0017-03LWE
16	Install new Audio/COMMAND control panel (A40/9) into cover on center console
		Model 213.0/2	AR54.21-P-0501LWE
17	Retrofit touchpad wiring harness		AN82.60-P-0017-01LWE
18	Transfer GPS antenna electrical line	Model 213.0/2 except code 355 (Pre-installation for navigation retrofit) except code 357 (Map navigation)	AN82.85-P-0007-07LWE
19	Modify plug housing for electrical wiring harness for reversing camera	Model 213.0/2 with code 218 (Reversing camera)	AN82.85-P-0009-07LWE
20	Modify electric line for audio/COMMAND display		AN82.85-P-0009-05LWO
21	Retrofit electrical wiring harness for instrument cluster	Fix electrical wiring harness for instrument cluster in place only after routing all retrofit wiring harnesses.	AN82.85-P-0009-06LWO
	Risk of injury caused by burns to skin and eyes, risk of poisoning caused by inhaling fumes during soldering.	Wear protective gloves, protective clothing and safety glasses. Ensure that the work area is adequately ventilated. Secure power supply cables. Avoid sources of fire in working area.	AS00.19-Z-0002-01A
22	Retrofit touchpad wiring harness in area of center console Notes on the use of paint scraping nuts on ground connections		AH00.19-P-1000-20A
	Notes on soft soldering		AH00.19-P-1000-07A
	Location of Z-connector sleeves (line connections in wiring harness) - interior compartment left	Model 213.0/2 up to model year 2021	GF00.19-P-3001-04DBA
	Location of end sleeves - Left vehicle interior	Model 213.0/2 as of model year 2021	GF00.19-P-3005-14DDA
	Repairing wiring harness using solder connectors		AR00.19-P-0100-09A
		Model 213.0/2 Fix touchpad wiring harness in place only after routing all retrofit wiring harnesses.	AN82.60-P-0017-04LWE
		Ground point for electromagnetic compatibility (touchpad)	*BA00.19-P-1032-02A
		Left center console ground point	*BA00.19-P-1012-02A
		Adapter	Fig 3
		Reflector	Fig 4
		Welding bead catcher	Fig 1
		Wiring harness repair kit, basic	Fig 5
		New passenger car wiring harness repair kit	Fig 2
23	Install footrest (3)
24	Install ventilation duct (4)
25	Close covers of cable ducts (6)
26	Insert a fuse with a fuse rating of 5 A into slot "MF3" of the fuse box on the front passenger side A-pillar (F1/3)
	Assignment of passenger-side A-pillar fuse box	Model 213.0/2 up to model year 2021	GF54.15-P-1256-48FG
	Wiring diagram of passenger-side A-pillar fuse box	Model 213.0/2 as of model year 2021	PE54.15-P-2519DDA
		The slot "MF3" of the fuse box on the front passenger side A-pillar (F1/3) is labeled.
27	Install front floor covering on front passenger side
			AR68.20-P-2065LWE
28	Fix rear floor covering (5) in place
29	Install front passenger seat
			AR91.10-P-1000LW
30	Install driver seat
		Model 213 1#	AR91.10-P-1000LW
31	Install HERMES control unit
			AR82.95-P-0019LWE
32	Install new head unit (A26/17)
			AR82.85-P-1101LWE
33	Install remaining parts
	Update Vehicle Documentation (VeDoc)
34	Delete special equipment in on-line vehicle data card	Code 506 (Audio 20 radio NTG 5.5)
35	Delete special equipment in on-line vehicle data card	Model 213.0/2 with code 355 (Preinstallation for navigation retrofit) Code 355 (Preinstallation for navigation retrofit) Model 213.0/2 with code 357 (Map navigation) Code 357 (Card navigation)
36	Enter special equipment in on-line vehicle data card	Code 531 (COMMAND APS) Code 08U (Vehicle setup) Code 12U (Concierge service) Code 14U (Smartphone integration package) Code 16U (Smartphone integration Carplay) Code 17U (Smartphone integration Goggle Automotive Link) Code 448 (Touch pad)
37	Attach "COMMAND APS retrofitted in accordance with AN82.85-P-0009LWH" note under field organization texts to design group 54 and design group 82
38	Connect diagnostic system and select vehicle via the vehicle identification number (VIN)
			AD00.00-P-2000-04B
39	Carry out variant coding using software calibration number (SCN)	Instrument cluster Head unit HERMES control unit Electronic ignition switch control unit Climate control, control unit Model 213.0/2 with code 641 (Dynamic left-hand traffic LED headlamps), model 213.0/2 with code 642 (Dynamic right-hand traffic LED headlamps) Headlamp range adjustment control unit Model 213.0/2 with code 235 (Active Parking Assist with PARKTRONIC) Parktronic system control unit Model 213.0/2 with code 233 (DISTRONIC PLUS) Mercedes-Benz Intelligent Drive control unit
40	Disconnect diagnostic system
			AD00.00-P-2000-04B
	Check
41	Perform function test	See Owner's Manual.