Gasoline injection and ignition system (ME-SFI) diagnosis - diagnostic trouble code memory - AD07.61-P-4000BA
ENGINES 113.940 /942 /943 up to 31.5.00,
113.961
Fault codes from P0305 to P0743
| Hazard from contact with parts conducting high voltages. | Do not touch parts which conduct high voltages. Persons who wear electronic implants (e.g. heart pacemakers) must not carry out work on the ignition system. | AS15.10-Z-0001-01A | |
| Lethal hazard from being drawn into rotating vehicle parts | Do not reach into rotating parts. Wear closed and close-fitting work clothes. Secure area of rotating vehicle components against unauthorized access. |
AS00.00-Z-0004-01A | |
| Risk of explosion from fuel igniting, risk of poisoning from inhaling and swallowing fuel as well as risk of injury to eyes and skin from contact with fuel. | No fire, sparks, naked flames or smoking. Pour fuels only into suitable and appropriately marked containers. Wear protective clothing when handling fuel. |
AS47.00-Z-0001-01A | |
| Notes on avoiding damage to the ignition system | Engines 104, 111, 112, 113, 119, 120 with ME-SFI fuel injection and ignition system | AH15.10-P-0002-01D | |
| The fault code cannot be read out with the pulse counter | |||
| ■ Symbol for USA vehicles for activation of the malfunction indicator lamp CHECK ENGINE • Symbol for EURO3 vehicles for activation of the engine diagnosis malfunction indicator lamp (is indicated in the HHT as ■) The malfunction indicator lamp does not go on until a fault relevant for the exhaust system was stored during the last driving cycle (exception misfire "damaging to TWC", malfunction indicator lamp goes on immediately). |
|||
| Ignition: On | |||
| Connect hand-held-tester (HHT), read out diagnostic trouble code memory | AD00.00-P-2000-03A | ||
| Gasoline injection and ignition system (ME-SFI) diagnosis - prerequisites | AD07.61-P-2000B | ||
| Check and adjust engine | Engine diagnosis manual | ||
| Diagnostic trouble code memory | |||
| Fault code |
Possible cause | Note | Remedy |
| No fault code | No fault detected | Depending on the complaint, carry out testing of ME-SFI electrical system in full | AD07.61-P-6000B AD07.61-P-6001B AD07.61-P-6002B AD07.61-P-6003B |
| P0305 ■ • | A Misfire in cylinder 5 B Misfire in cylinder 5 "damaging to TWC" |
AD07.61-P-6001-15B AD07.61-P-6001-17B AD07.61-P-7002-01A AD07.61-P-7002-01B Compression pressure |
|
| Fault code description for misfires, ME-SFI | AD07.61-P-4000-11B | ||
| P0306 ■ • | A Misfire in cylinder 6 B Misfire in cylinder 6 "damaging to TWC" |
AD07.61-P-6001-16B AD07.61-P-6001-17B AD07.61-P-7002-01A AD07.61-P-7002-01B Compression pressure |
|
| Fault code description for misfires, ME-SFI | AD07.61-P-4000-11B | ||
| P0307 ■ • | A Misfire in cylinder 7 B Misfire in cylinder 7 "damaging to TWC" |
AD07.61-P-6001-20A AD07.61-P-6001-17B AD07.61-P-7002-01A AD07.61-P-7002-01B Compression pressure |
|
| Fault code description for misfires, ME-SFI | AD07.61-P-4000-11B | ||
| P0308 ■ • | A Misfire in cylinder 8 B Misfire in cylinder 8 "damaging to TWC" |
AD07.61-P-6001-21A AD07.61-P-6001-17B AD07.61-P-7002-01A AD07.61-P-7002-01B Compression pressure |
|
| Fault code description for misfires, ME-SFI | AD07.61-P-4000-11B | ||
| P0325 | Knock sensor on right | Connector line Knock sensor |
|
| Fault code description for knock sensor, ME-SFI | AD07.61-P-4000-12A | ||
| P0330 | Knock sensor on left | Connector line Knock sensor |
|
| Fault code description for knock sensor, ME-SFI | AD07.61-P-4000-12A | ||
| P0335 | Crankshaft position sensor (L5) | AD07.61-P-6001-09B | |
| Fault code description for crankshaft position sensor, ME-SFI | AD07.61-P-4000-13A | ||
| P0341 ■ • | Camshaft Hall sensor (B6/1) | AD07.61-P-6001-10B | |
| Fault code description for camshaft Hall sensor, ME-SFI | AD07.61-P-4000-14A | ||
| P0370 | Angle deviation for camshaft to crankshaft | Check basic adjustment of camshafts | |
| P0400 ■ | Exhaust gas recirculation malfunction (causal chain) | AD07.61-P-6000-27B | |
| Fault code description for exhaust gas recirculation malfunction (causal chain), ME-SFI | AD07.61-P-4000-50B | ||
| P0410 ■ • | Secondary air injection malfunction (causal chain) | AD07.61-P-6000-24B | |
| AD07.61-P-6000-25A | |||
| AD07.61-P-6000-26A | |||
| Fault code description for secondary air injection malfunction (causal chain), ME-SFI | AD07.61-P-4000-15A | ||
| P0422 ■ • | Effect of right three-way catalytic converter too low | Right three-way catalytic converter | |
| Fault code description for three-way catalytic converter effect too low, ME-SFI | AD07.61-P-4000-16B | ||
| P0432 ■ • | Effect of left three-way catalytic converter too low | Left three-way catalytic converter | |
| Fault code description for three-way catalytic converter effect too low, ME-SFI | AD07.61-P-4000-16B | ||
| P0440 ■ | Purge system leak (causal chain) | AD07.61-P-6000-30A | |
| AD07.61-P-6000-31A | |||
| Fault code description for purge system leak (causal chain), ME-SFI | AD07.61-P-4000-17A | ||
| P0441 ■ | Purge control valve (Y58/1) | AD07.61-P-6000-29A | |
| Function | AD07.61-P-6000-30A | ||
| Fault code description for purge system leak (causal chain), ME-SFI | AD07.61-P-4000-17A | ||
| P0442 ■ | Purge system slight leak | AD07.61-P-6000-31A | |
| Fault code description for purge system leak (causal chain), ME-SFI | AD07.61-P-4000-17A | ||
| P0443 ■ • | Purge control valve (Y58/1) | AD07.61-P-6000-29A | |
| Fault code description for purge control valve, ME-SFI | AD07.61-P-4000-19A | ||
| P0446 ■ | A Activated charcoal canister shutoff valve (causal chain) | AD07.61-P-6000-32A | |
| B Activated charcoal canister shutoff valve (Y58/4) | AD07.61-P-6000-33A | ||
| Fault code description for activated charcoal canister shutoff valve, ME-SFI | AD07.61-P-4000-20A | ||
| P0450 ■ | A Tank pressure sensor (B4/3) electrical fault B Tank pressure sensor (B4/3) electrical vibrations |
AD07.61-P-6000-33A Activated charcoal canister blocked |
|
| Fault code description for tank pressure sensor, ME-SFI | AD07.61-P-4000-21A | ||
| P0455 ■ | Purge system with severe leak or voltage supply for tank pressure sensor (B4/3) | AD07.61-P-6000-31A | |
| AD07.61-P-6000-33A | |||
| Fault code description for purge system leak (causal chain), ME-SFI | AD07.61-P-4000-17A | ||
| P0460 | Fuel level gage sensor | Read out IC | |
| Fault code description for misfires, ME-SFI | AD07.61-P-4000-11B | ||
| P0500 | A front left vehicle speed signal B rear left vehicle speed signal |
Check ASR in chassis diagnosis manual, index 9 AD42.45-P-1000AZ |
|
| Fault code description for vehicle speed signal, ME-SFI | AD07.61-P-4000-23A | ||
| P0507 | Idle speed control implausible | AD07.61-P-6002-01C AD07.61-P-6002-01D AD07.61-P-6002-03A |
|
| Fault code description for idle speed control, ME-SFI | AD07.61-P-4000-24A | ||
| P0520 | Oil pressure sensor for cylinder cut-out system | CODE (479) for cylinder cut-out system | refer to STAR DIAGNOSIS |
| Fault code description for oil pressure sensor for cylinder cut-out system, ME-SFI | AD07.61-P-4000-58B | ||
| P0560 | Voltage supply to ME-SFI control module (N3/10) | AD07.61-P-6000-01B | |
| AD07.61-P-6000-02B | |||
| Fault code description for control module voltage supply, ME-SFI | AD07.61-P-4000-59A | ||
| P0565 | Pushbutton switch for variable cruise control (S40/4) | AD07.61-P-6003-01E | |
| P0600 | CAN of ESP | AD07.61-P-6000-34A | |
| Fault code description for CAN damaged, ME-SFI | AD07.61-P-4000-26A | ||
| P0604 | A ME-SFI control module (N3/10) B ME-SFI control module (N3/10) |
N3/10 | |
| P0605 | ME-SFI control module (N3/10) | N3/10 | |
| P0700 ■ | Read out diagnostic trouble code memory for ETC control module (N15/3) | AD27.19-P-6000A | |
| Fault code description for gear implausible or transmission with leaks, ME-SFI | AD07.61-P-4000-27A | ||
| Fault code description for command valve sticks in pressure position, ME-SFI | AD07.61-P-4000-28A | ||
| P0702 ■ | Read out diagnostic trouble code memory for ETC control module (N15/3) | AD27.19-P-6000A | |
| Fault code description for ETC control module, ME-SFI | AD07.61-P-4000-29A | ||
| Fault code description for valve supply voltage, ME-SFI | AD07.61-P-4000-30A | ||
| P0715 ■ | Read out diagnostic trouble code memory for ETC control module (N15/3) | AD27.19-P-6000A | |
| Fault code description for supply voltage and function of RPM sensors, ME-SFI | AD07.61-P-4000-31A | ||
| P0720 ■ | Read out diagnostic trouble code memory for ETC control module (N15/3) | AD27.19-P-6000A | |
| Fault code description for CAN fault identification, ME-SFI | AD07.61-P-4000-32A | ||
| P0730 ■ | Read out diagnostic trouble code memory for ETC control module (N15/3) | AD27.19-P-6000A | |
| Fault code description for gear comparison (multiple times) negative, ME-SFI | AD07.61-P-4000-33A | ||
| P0740 ■ | Read out diagnostic trouble code memory for ETC control module (N15/3) | AD27.19-P-6000A | |
| Fault code description for torque converter lockup clutch, ME-SFI | AD07.61-P-4000-34A | ||
| P0743 ■ | Read out diagnostic trouble code memory for ETC control module (N15/3) | AD27.19-P-6000A | |
| Fault code description for PWM-solenoid of torque converter lockup, ME-SFI | AD07.61-P-4000-35A |