Section 18 (Engine Starting System (VIN A))
WARNING: This page is about a different variant/trim than selected.
- Starter Inspection [PYUL]
- Starter Removal/Installation [PYUL]
- D-code
- Remove Capsule Cover
- High Voltage Part Inspection And Removal/Installation Notes
- Remove Cover Assembly (Passenger's Side)
- Disconnect Negative Lead-Acid Battery Terminal
- Remove 150 W Power Supply Unit
- Remove Service Hole Cover (High Voltage Battery)
- Remove Service Plug
- Remove Front Under Cover No. 3
- Remove Floor Under Cover (Left side)
- Remove Rear Under Cover No. 1 (Left Side)
- Remove Terminal Cover (High Voltage Battery Side)
- Perform High Voltage Handling
- Remove Air Cleaner Component
- Remove Cover Assembly (Driver's Side)
- Remove Driver's Side Wiper Arm Cover
- Remove Driver's Side Windshield Wiper Arm And Blade
- Remove Passenger's Side Wiper Arm Cover
- Remove Passenger's Side Windshield Wiper Arm And Blade
- Remove Cowl Grille
- Remove Side Cowl Grille (Driver's Side)
- Remove Side Cowl Grille (Passenger's Side)
- Remove Windshield Wiper Motor And Link
- Remove Driver Side Strut Tower Bar
- Remove Passenger Side Strut Tower Bar
- Remove Engine Compartment Insulator (Upper)
- Remove A/C Compressor Bracket (with USA/Canada spec)
- Remove ECM
- Remove Intake Manifold
- Remove Starter
- Install in Reverse Order of Removal
- Perform Power Liftgate Initialization
- Initialize Power Outer Mirror Retract/Return Function
- Perform Windshield Wiper Arm And Blade Initial Setting
- Starting System Location Index [PYUL]