LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 584 (Security System And Locks System) >> Door Lock-Link Switch Inspection >> Rear Door Lock-link Inspection

Rear Door Lock-link Inspection

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fully open the rear door glass.
  2. Disconnect the negative battery cable.
  3. Remove the following parts:
    1. Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION .)
    2. Rear door trim (See REAR DOOR TRIM REMOVAL/INSTALLATION .)
    3. Rear inner handle (See INNER HANDLE REMOVAL/INSTALLATION .)
    4. Rear door speaker (See REAR DOOR SPEAKER REMOVAL/INSTALLATION .)
    5. Rear door quarter glass (See REAR DOOR QUARTER GLASS REMOVAL/INSTALLATION .)
    6. Rear door glass (See REAR DOOR GLASS REMOVAL/INSTALLATION .)
    7. Rear door module panel (See REAR DOOR MODULE PANEL REMOVAL/INSTALLATION .)
    8. Rear door latch and lock actuator (See REAR DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION .)
  4. If the door lock condition is to be inspected, pull the door lock-link switch cable, or press it in.
    NOTE:
    • The door lock-link switch cable locks or unlocks only when the latch lever is locked.
    Fig 1: Identifying Door Lock-Link Switch Cable Lock Or Unlock Position
    G06200918Courtesy of MAZDA MOTORS CORP.
  5. Verify that the continuity is as indicated in the table.
    Fig 2: Identifying Door Lock-Link Switch Circuits With Connectors
    G06200919Courtesy of MAZDA MOTORS CORP.
    • If not as indicated in the table, replace the front door latch and lock actuator.
    Fig 3: Door Lock-Link Switch Continuity Table
    G06200920Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals