LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 584 (Security System And Locks System) >> Rear Door Latch And Lock Actuator Removal/Installation

Rear Door Latch And Lock Actuator Removal/Installation

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fully open the rear door glass
  2. Disconnect the negative battery cable.
  3. Remove the following parts:
    1. Rear door trim (See REAR DOOR TRIM REMOVAL/INSTALLATION .)
    2. Rear inner handle (See INNER HANDLE REMOVAL/INSTALLATION .)
    3. Rear door speaker (See REAR DOOR SPEAKER REMOVAL/INSTALLATION .)
    4. Rear door quarter glass (See REAR DOOR QUARTER GLASS REMOVAL/INSTALLATION .)
    5. Rear door glass (See REAR DOOR GLASS REMOVAL/INSTALLATION .)
    6. Rear door module panel (See REAR DOOR MODULE PANEL REMOVAL/INSTALLATION .)
  4. Remove the screw.
    5. Fig 1: Rear Door Latch And Lock Actuator Mounting Screw With Torque Specifications
    G06200925Courtesy of MAZDA MOTORS CORP.
  5. Remove the rear door latch and lock actuator.
  6. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals