Antenna Feeder No. 2 Inspection

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the following parts:
1. A-pillar trim (RH). See A-PILLAR TRIM REMOVAL/INSTALLATION .
2. Rear scuff plate (RH). See REAR SCUFF PLATE REMOVAL/INSTALLATION .
3. Rear seat cushion. See REAR SEAT CUSHION REMOVAL/INSTALLATION .
4. Rear side seat back (RH). See REAR SIDE SEAT BACK REMOVAL/INSTALLATION .
5. C-pillar trim (RH). See C-PILLAR TRIM REMOVAL/INSTALLATION .
Disconnect the antenna feeder No. 1.

Fig 1: Identifying Antenna Feeder No. 1
Courtesy of MAZDA MOTORS CORP.
Disconnect the antenna feeder No. 3.

Fig 2: Identifying Antenna Feeder No. 3
Courtesy of MAZDA MOTORS CORP.
Verify that the continuity between antenna feeder No. 2 terminals is as indicated in the table.
- If not as indicated in the table, replace antenna feeder No. 3.
  
  Fig 3: Test Condition Terminal Chart
  Courtesy of MAZDA MOTORS CORP.
  
  Fig 4: SIRIUS Satellite Radio System Circuit Diagram
  Courtesy of MAZDA MOTORS CORP.