LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1301 (Front Suspension & Wheel Alignment) >> Front >> Arm, Lower Control >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Remove the tire and wheel assembly. Refer to REMOVAL .
  3. Remove the front fascia. Refer to FASCIA, FRONT, REMOVAL .
  4. Remove the front recovery hook if equipped. Refer to HOOK(S), TOW, FRONT, REMOVAL AND INSTALLATION .
  5. Remove the lower load beam. Refer to LOAD BEAM, LOWER, REMOVAL .
  6. Remove the front stabilizer bar links. Refer to LINK, STABILIZER BAR, REMOVAL  .
  7. Remove the front hub nut. Refer to HUB AND BEARING, REMOVAL  .
  8. Remove the outer tie rod end from the knuckle. Refer to REMOVAL, OUTER TIE ROD .
    GC0189498Courtesy of CHRYSLER GROUP, LLC
  9. Remove the lower control arm to knuckle bolt (1) and remove the lower control arm (3) from the knuckle (4).
  10. Remove the halfshaft from the hub and bearing.
    NOTE:

    Properly support the halfshaft.

    GC0189088Courtesy of CHRYSLER GROUP, LLC
  11. Remove the lower control arm to cradle rear bolt (1).
    GC0190052Courtesy of CHRYSLER GROUP, LLC
  12. Remove the lower control arm to cradle front bolt (1), and remove the lower control arm from the vehicle.
scientia non olet · About LEMON Manuals