LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1287 (Frame And Bumpers) >> Bumpers >> Fascia, Front >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0190337Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Using a trim stick or equivalent, release the retaining clips at the front of the wheel moldings (2) and position aside.
  3. Remove the screws (1) on each side of the vehicle.
    GC0165464Courtesy of CHRYSLER GROUP, LLC
  4. Remove the screws (1) securing the front wheel splash shields to the fascia.
    GC0165232Courtesy of CHRYSLER GROUP, LLC
  5. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  6. Remove the screws (1).
    GC0166157Courtesy of CHRYSLER GROUP, LLC
  7. Lower the vehicle.
  8. Remove the screws (1a) and position the release handle (1b) aside.
  9. Disconnect the wire harness connectors (3) from the head lamps.
  10. Remove the screws (2) at the top of the front fascia (4).
    GC0188936Courtesy of CHRYSLER GROUP, LLC
  11. Remove the fasteners (1) from above each headlight assembly.
    GC0180819Courtesy of CHRYSLER GROUP, LLC
  12. Release the sides of the front fascia (2) from the fender bracket. Repeat on the opposite side.
  13. With the use of a plastic pry tool or equivalent, release the grill from the metal clip (1), securing the grill to the fender. Repeat on the opposite side.
  14. If equipped, disconnect the wire harness connectors from the fog lamps.
  15. Remove the front fascia.
scientia non olet · About LEMON Manuals