LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1301 (Front Suspension & Wheel Alignment) >> Front >> Link, Stabilizer Bar >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Remove the tire and wheel assembly. Refer to REMOVAL .
    GC0190933Courtesy of CHRYSLER GROUP, LLC
  3. Remove and DISCARD  the stabilizer bar link bolt (2) at the stabilizer bar. Separate the stabilizer bar link from the stabilizer bar.
  4. Remove and DISCARD  the stabilizer bar link bolt (1) at the front strut. Separate the stabilizer bar link from the front strut.
  5. Remove the stabilizer bar link.
scientia non olet · About LEMON Manuals