Front Fender Replacement - Right Side

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Fender Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the headlamp. Refer to Headlamp Replacement (Non HID) or Headlamp Replacement (Cadillac Escalade) or Headlamp Replacement (Yukon) or Headlamp Replacement (Tahoe, Avalanche) or Headlamp Replacement (Chevrolet Tahoe Two-mode Hybrid) or Headlamp Replacement (GMC Yukon Two-mode Hybrid) . Remove the upper rear fender bracket. Refer to Front Fender Rear Upper Bracket Replacement . Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement . Remove the air cleaner box tray. Remove the coolant reservoir bottle from the right fender and set it aside. Do not open the cooling system. Refer to Radiator Surge Tank Replacement (Non-HP2) or Radiator Surge Tank Replacement (HP2) . Remove the battery tray. Refer to Battery Tray Replacement . Remove the right hood hinge. Refer to Hood Hinge Replacement . Remove the right hood link. Refer to Hood Link Replacement . Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Right Side .
1	Fender Mounting Bolt (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 25 N.m (18 lb ft)
2	Fender Mounting Bolt (Qty: 3) Tighten: 30 N.m (22 lb ft) Procedure: Apply threadlock compound to the bolts.
3	Fender Mounting Clip (Qty: 3)
4	Fender Assembly Tip: Transfer any necessary additional parts as needed.