Headlamp Replacement (Chevrolet Tahoe Two-mode Hybrid)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Headlamp Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement (Escalade) or Front Bumper Fascia Replacement (Tahoe) or Front Bumper Fascia Replacement (Avalanche) or Front Bumper Fascia Replacement (Z71) or Front Bumper Fascia Replacement (Yukon) . Remove the 2 upper headlamp bolts. Grasp the headlamp at the upper inboard and lower outboard side and pull the headlamp forward to disengage the locating pins from the fender panel. Pull the outboard side of the headlamp forward until the locating pin is disengaged from the radiator support. Disconnect the electrical harness connector.
1	Headlamp Bolt NOTE: Refer to Fastener Notice . Tighten: 6 N.m (53 lb in)
2	Headlamp Bolts Tighten: 6 N.m (53 lb in)
3	Forward Lamp Harness Electrical Connector
4	Headlamp Assembly Procedure Upon re-assembly, align the locating tab along with the outer locating pins prior to applying inward pressure to the headlamp assembly. Aim the headlamp assembly. Refer to Headlamp Aiming (Tahoe/Yukon) or Headlamp Aiming (Escalade) .