LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Link Replacement

Hood Link Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Hood Hinge Spring & Bolt
GM1670886Courtesy of GENERAL MOTORS CORP.
Callout Component Name
CAUTION: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Preliminary Procedures

  1. Prop and support the hood.
  2. Remove the hood link upper bolt. Refer to Hood Replacement 
1 Hood Link Lower Bolt
NOTE: Refer to Fastener Notice .

Tighten:  25 N.m (18 lb ft)

2 Hood Link