Section 1156 (Transfer Case - BW 4477)
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Repair Instructions - On Vehicle
- Repair Instructions - Off Vehicle
- Transfer Case Disassemble
- Transfer Case Cleaning and Inspection
- Front Output Shaft Front Bearing Replacement
- Input Shaft Bearing Replacement
- Rear Output Shaft Rear Bearing Replacement
- Front Output Shaft Seal Replacement
- Input Shaft Seal Replacement
- Rear Output Shaft Seal Replacement
- Transfer Case Assemble
- Coil Installation
- Chain Snubber and Vent Baffle Installation
- Chain, Sprockets, Oil Pump, Input Shaft, and Front Output Shaft Installation
- Apply Cam, and Clutch Pack Installation
- Case Half and Front Output Shaft Hole Plug Installation
- Dampener and Rear Output Flange Installation
- Vent Assembly, Drain Plug, Fill Plug, and Temperature Switch Installation
- Four Wheel Drive Clutch Shim Selection
- Description and Operation
- Special Tools and Equipment