LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1564 (Body - Interior & Exterior - 2500 Hd) >> Instrument Panel >> Panel, Instrument >> Removal

Panel, Instrument: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and personal or fatal injury.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the front seat assembly. Refer to SEAT, FRONT CENTER, REMOVAL .
    GC0083755Courtesy of CHRYSLER GROUP, LLC
  3. Remove the left cowl trim panel. Refer to PANEL, COWL TRIM, REMOVAL .
  4. Remove the steering column opening cover Refer to COVER, STEERING COLUMN OPENING, REMOVAL .
  5. Disconnect the instrument panel wire harness connector (2) located above the brake pedal from the bulkhead wire harness connector (1).
    GC0089022Courtesy of CHRYSLER GROUP, LLC
  6. Remove the steering column as necessary. Refer to COLUMN, REMOVAL .
  7. Remove the steering column bracket bolts (1).
    G00673986Courtesy of CHRYSLER GROUP, LLC
  8. Using a (special tool #C-4755, Trim Stick) or equivalent, remove the trim panel (1) from the instrument panel.
    GC0154378Courtesy of CHRYSLER GROUP, LLC
  9. Remove the bolts (1) and position the manual park release lever (2) aside.
  10. Remove the hood release handle and position aside. Refer to CABLE, HOOD RELEASE, REMOVAL .
    GC0154525Courtesy of CHRYSLER GROUP, LLC
  11. Disconnect the park brake release handle (1) link (2).
    GC0154584Courtesy of CHRYSLER GROUP, LLC
  12. Remove the left A-pillar trim. Refer to PANEL, A-PILLAR TRIM, WITH GRAB HANDLE, REMOVAL .
  13. Using a trim stick (special tool #C-4755, Trim Stick) or equivalent, from the notch on the bottom, remove the left instrument panel side cover.
    GC0089023Courtesy of CHRYSLER GROUP, LLC
  14. Disconnect the headliner wire harness connector (2), release the push pin (1) located at the A-pillar, and position the harness aside.
    GC0154604Courtesy of CHRYSLER GROUP, LLC
  15. Remove the three bolts (1) that secure the left side of the instrument panel to the dash panel.
  16. Remove the floor console, if equipped. Refer to CONSOLE, FLOOR, LID, REMOVAL .
  17. Remove the Brake Sled to I/P Bolts
    GC0089024Courtesy of CHRYSLER GROUP, LLC
  18. Remove the two bolts (1) that secure the instrument panel to the center of the floor panel.
    GC0089025Courtesy of CHRYSLER GROUP, LLC
  19. Remove the glove box from the instrument panel. Refer to REMOVAL .
  20. Disconnect the five instrument panel wire harness connectors from the two body wire harness connectors (1) located on the right side of the cowl panel (2).
    GC0083756Courtesy of CHRYSLER GROUP, LLC
    GC0083757Courtesy of CHRYSLER GROUP, LLC
  21. Disconnect the antenna coaxial cable connectors (1) from the radio coaxial cable connector (2) located on the right side of the cowl panel.
    GC0154531Courtesy of CHRYSLER GROUP, LLC
  22. Remove the three bolts (1) that secure the right side instrument panel bracket to the dash panel.
    GC0089015Courtesy of CHRYSLER GROUP, LLC
  23. Remove fence line bolt access covers.
  24. Remove fence line bolts.
  25. Pull carpet back as necessary to remove the ground eyelet fastener at ORC/YAWL Modules.
  26. Disconnect the ORC Module electrical connector and remove the wiring from under the carpet.
  27. With the help of an assistant, lift the instrument panel up and off of the cowl panel and remove the instrument panel from the vehicle.