LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1562 (Steering System - 2500 Hd) >> Column >> Removal

Section 1562 (Steering System - 2500 Hd): Column: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Before servicing the steering column, the airbag system must be disarmed. Refer to RESTRAINTS - (SERVICE INFORMATION) - 2500 HD & 3500 HD for service procedures. Failure to do so may result in accidental deployment of the airbag and possible personal injury.

CAUTION:

All fasteners must be torqued to specification to ensure proper operation of the steering column.

NOTE:

1500 series shown, others similar.

GC0088318Courtesy of CHRYSLER GROUP, LLC
  1. Position the front wheels straight ahead  .
  2. Disconnect the negative battery cable from the battery.
  3. Remove the airbag. Refer to AIR BAG, DRIVER, REMOVAL .
  4. Partially remove the steering wheel bolt (1) and leave the bolt in the column.
    NOTE:

    The jaws should point outward from the center of the steering wheel for removal. 

  5. Install Gear Puller (special tool #L-4407A, Puller, Gear) (1) and OTC® 7929A Steering Wheel Puller Leg Set or equivalent and loosen the steering wheel.
  6. Remove the tool and steering wheel bolt (1), and discard the steering wheel bolt (1).
    NOTE:

    Route the harness through the steering wheel during removal.

  7. Remove the steering wheel (2).
  8. Remove the clock spring. Refer to CLOCKSPRING, REMOVAL .
  9. Remove the upper and lower column shrouds. Refer to SHROUD, STEERING COLUMN, REMOVAL .
  10. Disconnect the wiring harness routing retainers and connectors to the various components of the steering column.
    GC0088316Courtesy of CHRYSLER GROUP, LLC
  11. If equipped with a floor shift, remove the shift cable from the routing clip (1).
  12. If equipped with a column shift, disconnect the shift cable from the shift assembly lever and remove the cable from the bracket.
  13. Remove the stop lamp sensor (3). Refer to SENSOR, STOP LAMP, REMOVAL .
  14. Remove the upper steering shaft coupler bolt (4) and discard. Separate the shaft from the coupler.
  15. Remove the forward steering column mounting nuts (5).
  16. Support the steering wheel and remove the forward steering column mounting nuts (2).
  17. Remove the steering column assembly from the vehicle.
  18. Remove and transfer any necessary components.
scientia non olet · About LEMON Manuals