Installation Procedure
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- With the aid of an assistant, position the headliner trim panel assembly (2) into the vehicle through the liftgate opening.
- Connect the electrical connectors to the headliner trim panel assembly (2).
- Tape any unused connectors to the headliner with a high adhesive tape.
- Install the 3 headliner trim panel retainers (1).
- Install the body lock pillar upper trim panel (3). Refer to Body Lock Pillar Upper Trim Panel Replacement .
- Install the center pillar upper trim panel assembly (3). Refer to Center Pillar Upper Trim Panel Replacement (Trax) .
- Install the rear seat position center courtesy lamp (1). Refer to Rear Seat Position Center Courtesy Lamp Replacement .
- Install the roof console assembly (2). Refer to Roof Console Replacement .
- Install the windshield outside moisture sensor cover (1). Refer to Windshield Outside Moisture Sensor Cover Replacement (Trax) .
- Install the roof rail front stowage compartment (2). Refer to Roof Rail Front Stowage Compartment Replacement (Trax) .
- Install the roof rail rear assist handle assembly (2). Refer to Roof Rail Rear Assist Handle Replacement (Trax) .
- Install the roof rail assist handle assembly (2). Refer to Roof Rail Assist Handle Replacement (Trax) .
- Install the sunshade support assembly (2). Refer to Sunshade Support Replacement (Trax) .
- Install the sunshade assembly (3). Refer to Sunshade Replacement (Trax) .
- Install the windshield garnish molding assembly (1). Refer to Windshield Garnish Molding Replacement (Trax) .
- Enable the SIR system. Refer to SIR Disabling and Enabling .