Driver or Passenger Seat Cushion Frame Replacement

Fig 1: Front Seat Cushion Frame And Bolts

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: Refer to SIR Warning . Preliminary Procedure Remove the front seat. Refer to Driver or Passenger Seat Replacement . Remove the front seat outer adjuster finish cover. Refer to Driver or Passenger Seat Outer Adjuster Finish Cover Replacement (with Manual Height Adjuster) , Driver or Passenger Seat Outer Adjuster Finish Cover Replacement (with Power Height Adjuster) . Remove the front seat inner recliner finish cover. Refer to Driver or Passenger Seat Inner Recliner Finish Cover Replacement . Remove the front seat cushion cover and pad. Refer to Front Seat Cushion Cover and Pad Replacement . When working with the passenger seat re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References .
1	Front Seat Back Cushion Frame Bolt (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten 35 N.m (26 lb ft)
2	Front Seat Cushion Frame Procedure Disconnect electrical connectors as needed. When replacing the front passenger seat cushion, you must also replace the inflatable restraint front passenger mass sensor. Refer to Inflatable Restraint Front Passenger Mass Sensor Replacement . If replacing with a new front seat cushion frame, transfer components as necessary.

Callout

Component Name

WARNING:

Preliminary Procedure

Remove the front seat. Refer to Driver or Passenger Seat Replacement .
Remove the front seat outer adjuster finish cover. Refer to Driver or Passenger Seat Outer Adjuster Finish Cover Replacement (with Manual Height Adjuster) , Driver or Passenger Seat Outer Adjuster Finish Cover Replacement (with Power Height Adjuster) .
Remove the front seat inner recliner finish cover. Refer to Driver or Passenger Seat Inner Recliner Finish Cover Replacement .
Remove the front seat cushion cover and pad. Refer to Front Seat Cushion Cover and Pad Replacement .
When working with the passenger seat re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References .

Front Seat Back Cushion Frame Bolt (Qty: 4)

CAUTION:

Tighten
35 N.m (26 lb ft)

Front Seat Cushion Frame

Procedure

Disconnect electrical connectors as needed.
When replacing the front passenger seat cushion, you must also replace the inflatable restraint front passenger mass sensor. Refer to Inflatable Restraint Front Passenger Mass Sensor Replacement .
If replacing with a new front seat cushion frame, transfer components as necessary.