Driver or Passenger Seat Outer Adjuster Finish Cover Replacement (with Manual Height Adjuster)

Fig 1: Front Seat Outer Adjuster Finish Cover And Screws (with Manual Height Adjuster)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the front seat recliner lever knob, if necessary. Refer to Driver Seat Recliner Lever Knob Replacement Remove the front seat adjuster vertical actuator handle cover. Refer to Driver or Passenger Seat Adjuster Vertical Actuator Handle Replacement
1	Driver or Passenger Seat Outer Adjuster Finish Cover Rear Screw
2	Driver or Passenger Seat Outer Adjuster Finish Cover Side Screw TIP: Lift up on the seat back recliner adjuster handle to gain access to finish cover side screw.
3	Driver or Passenger Seat Outer Adjuster Finish Cover Front Screw
4	Driver or Passenger Seat Outer Adjuster Finish Cover Procedure Disconnect the electrical connectors. Firmly grasp the upper area of the finish cover that folds over the seat cushion frame, this area needs to be flexed outward while sliding the finish cover rearward. If replacing the cover, transfer components as necessary.